Anonymous posted an answer for this 2003 Chevrolet Malibu:
"You may have air trapped in the system. Air can get sucked into the system if you have a..."
Anonymous posted an answer for this 2003 Chevrolet Malibu:
"my malibu 03 heats up could the radiator be clogged? i changed the spark plugs plus the..."
Anonymous posted an answer for this 2004 Ford Crown Victoria:
"I'm assuming that when you press on your horn pad the horn isn't working. So you are..."
Anonymous posted an answer for this 2004 Ford Crown Victoria:
"How to check if a horn works"
Anonymous posted an answer for this 2004 Ford Crown Victoria:
"You need to replace your resistor. It is located on the firewall of the engine..."
Anonymous posted an answer for this 2004 Ford Crown Victoria:
"my fan will only work on the "High" selection, the other three selection don't..."
Anonymous posted an answer for this 2003 Ford Crown Victoria:
"I just recently had that problem on one of our '03 Crown Vics and we had to change out the..."
Anonymous posted an answer for this 2003 Ford Crown Victoria:
"okay I have a 2004 ford crown turn signals don't work when I turned the turn signal..."
Anonymous posted an answer for this 2003 Ford Crown Victoria:
"Is the check engine light on? I would first inspect the air filter, change it if it..."
Anonymous posted an answer for this 2003 Ford Crown Victoria:
"When I start to go the car goes but if I punch it or just put the pedal down a ways it..."
Anonymous posted an answer for this 2000 Ford Crown Victoria:
"So change the thermostat and see what happens."
Anonymous posted an answer for this 2000 Ford Crown Victoria:
"Losing coolant? Might have an intake leak."
Anonymous posted an answer for this 2000 Ford Crown Victoria:
"2000 Crown Vic interceptor.. Car normally runs n drives like a champ.. Lately Ive noticed..."
Anonymous posted an answer for this 2000 Ford Crown Victoria:
"The trunk release button will do the job. If the ignition needs to be on for the trunk..."
Anonymous posted an answer for this 2000 Ford Crown Victoria:
"On my 2000 ford crown vic. the power door locks work except for the drivers side. sounds..."
Anonymous posted an answer for this 1998 Dodge Intrepid:
"Try replacing the fuse, on the 2004's the number 14 fuse supplies the sunroof and cluster..."
Anonymous posted an answer for this 2004 Dodge Intrepid:
"What may have happened is either the headlights wiring or the parking lights wiring..."
Anonymous posted an answer for this 2008 Ford Crown Victoria:
"The fuel filter is located under the vehicle on the inner side of the left (driver side)..."
Anonymous posted an answer for this 2003 Dodge Intrepid:
"Really depends on the engine you have. If you have a 3.3 L engine then the water pump is a..."
Anonymous posted an answer for this 1999 Dodge Intrepid:
"Well you need to check the harness to see if it is getting power. You may need to take the..."
Anonymous posted an answer for this 2001 Ford Crown Victoria:
"Depends on what door trim you are trying to replace. If you are trying to replace the door..."
Anonymous posted an answer for this 2001 Ford Crown Victoria:
"The backseats of this vehicle do not fold down. They are placed on hooks and then they're..."
Anonymous posted an answer for this 2002 Ford Crown Victoria:
"According to Ford the fuel pumps are located in the fuel tank. If you need help with this..."
Anonymous posted an answer for this 2002 Ford Crown Victoria:
"Wow money hungry, they are. Did you try to reset the fuel pumps inertia switch located in..."
Anonymous posted an answer for this 2003 Ford Crown Victoria:
"There is both a fuse and a relay for the fuel pumps electrical system. The image below of..."
Anonymous posted an answer for this 2003 Ford Crown Victoria:
"Drain the oil from the system. Next remove the oil pan and reinstall a new oil pan and new..."
Anonymous posted an answer for this 2003 Ford Crown Victoria:
"Also if you want to test the catalytic converter before you replace it. To do this remove..."
Anonymous posted an answer for this 1999 Ford Crown Victoria:
"It sounds like the LCM (Lighting Control Module) which is a black box located directly..."
Anonymous posted an answer for this 2004 Dodge Intrepid:
"Well let me give you a brief understanding of the electrical ignition system. The PCM..."
Anonymous posted an answer for this 1999 Dodge Intrepid:
"Inner main bearing cap bolts: Torque to 15 ft-lbs, then rotate an additional 1/4 turn..."
Anonymous posted an answer for this 1999 Dodge Intrepid:
"Below are the steps needed to remove the catalytic converters. You may be able to first..."