2
Anonymous posted an answer for this 2003 Ford Crown Victoria:
"What rims are on the car the steel police ones and what tires are on it could be hitting..."
AnonymousAnonymous posted an answer for this 2003 Ford Crown Victoria:
"The switch plate just sits in there with clip be very carful not to break the plastic clip..."
Anonymous
Anonymous posted an answer for this 1991 Ford F250:
"coil could be breaking down after it gets hot which means you need a new one .after it..."
Anonymous
Anonymous posted an answer for this 2003 Ford Escape:
"sur it is a grind and not like the ABS is going off which could mean a sensor is bad or..."
Anonymous
Anonymous posted an answer for this 1998 Ford Taurus:
"try taking the switch plate off and putting back on incase it was not making contact or..."
Anonymous
Anonymous posted an answer for this 2002 Ford E250:
"Well Iknow on my explorer it is the long jack handle under the back seat so on the van I..."
Anonymous
Anonymous posted an answer for this 1996 Ford Ranger SuperCab:
"did you think of changing the crank senor that would mor and likely be the problem if you..."
AnonymousAnonymous posted an answer for this 2007 Ford F:
"it could be the plug where it connects up under neith try twisting it there while the..."
Anonymous
Anonymous posted an answer for this 1998 Ford Expedition:
"try buying a 24mm wrench and just put a litle bend in it and a long screw driver to give..."
AnonymousAnonymous posted an answer for this 1998 Ford Expedition:
"P0133 is a 02 sensor circuit slow response bank 1 sensor 1 .which means you need a new 02..."
Anonymous
Anonymous posted an answer for this 2001 Chrysler Concorde:
"you can but what are the price of the parts .just a pain to get at the fittings just make..."
Anonymous
Anonymous posted an answer for this 2001 Ford F250 Super Duty Super Cab:
"there could be a flat spot in the motor that runs the blade"
Anonymous
Anonymous posted an answer for this 2004 Ford F150:
"it could be the switch plate on the drivers side cause it powers all the others"
Anonymous
Anonymous posted an answer for this 1994 Ford F350 Crew Cab:
"well have it flushed troque converter and everything and put new fluild in it and see..."
Anonymous
Anonymous posted an answer for this 1994 Chevrolet S-10:
"well it could be just a matter of cleaning out the leaf screen or pull the heater fan more..."
AnonymousAnonymous posted an answer for this 1999 Chevrolet Suburban:
"what about the sockets of the lights are they rusted in the contact spot and touching the..."
Anonymous
Anonymous posted an answer for this 2001 Dodge Durango:
"change the thermatstat it has aweak spring in it .could fail all together and over heat"
Anonymous
Anonymous posted an answer for this 2002 Chrysler PT Cruiser:
"Does the abs light come on when pulsating? if yes then maybe you have a bad ABS sensor or..."
Anonymous
Anonymous posted an answer for this 1993 Plymouth Grand Voyager:
"are you sure it is that and just not the temperature sensor that tells it to come on bad..."
Anonymous
Anonymous posted an answer for this 1999 Chrysler 300M:
"are they the original struts in the front .if so replace the strots and strut plates ."
Anonymous
Anonymous posted an answer for this 1996 Chevrolet Suburban:
"you need to replace the tumbler but first you can try a new key if you do not think its..."
Anonymous
Anonymous posted an answer for this 1998 Ford Windstar:
"I had same problem and it was the speed sensor on the transmission .The one that is in the..."
Anonymous
Anonymous posted an answer for this 1999 Ford Explorer:
"it more and likely the speed sensor onthe trannsimision"
Anonymous
Anonymous posted an answer for this 1998 Chrysler Cirrus:
"well could be a dried out lower ball joint or just the upper strutsare dried out and need..."
Anonymous
Anonymous posted an answer for this 2004 Nissan Sentra:
"then the water pump must be bad in it .Take the rad cap off and rev motor up if it goes..."
Anonymous
Anonymous posted an answer for this 2002 Ford Ranger Regular Cab:
"did they plug it in after they fixed it .my dad truck they fixed the wire but did not plug..."
Anonymous
Anonymous posted an answer for this 1999 Buick Century:
"what about changing the wires ? or just the no.2 with one of the other ones just to see if..."
AnonymousAnonymous posted an answer for this 1999 Ford Explorer:
"At 65000km I had too rebuild my tranny cause it would not shift into od when it did it..."
Anonymous
Anonymous posted an answer for this 1997 Ford Explorer AWD:
"is it in low if so then it needs to be in neutral to go back into high or auto"
AnonymousAnonymous posted an answer for this 1988 Volkswagen Golf:
"make sure the sensor on the air breather are plugged in or any other sensors"
Anonymous
Anonymous posted an answer for this 1997 Buick LeSabre:
"make sure the double cables you have are tight and no corrosion in between on"
Anonymous
Cars & Trucks 51 answers
