Press enter to search.
Anonymous posted an answer for this Hotpoint Aquarius WF000 Front Load Washer:
"on the wf you remove the lid and 2 screws that hold the console on at the front top.also..."
Anonymous posted an answer for this Hotpoint Ultima WF860 Front Load Washer:
"f04 is a pressure switc problem. take the lid off and check the clear plastic hose is..."
"if you remove one of the paddles from inside the drum you may be able to grab it with long..."
"f12 is an electrical connection problem between the 2 circuit boards of the machine. it..."
"it's the heater relay stuck. you will need a new power board. and heater."
"if ther3e are 2 hoses they will both need a water supply but you can get a 'y' connector..."
"remove the lid and the lower back panel. loop the belt over the motor shaft from the top..."
Anonymous posted an answer for this Hotpoint Ultima WD72 Front Load Washer/Dryer:
"you will need to check there is water flowing with enough pressure and your hoses are not..."
Anonymous posted an answer for this Indesit W 123 Front Load Washer:
"you will need to remove the pulley first, the screw in the middle will need a knock to..."
Anonymous posted an answer for this Hotpoint Ultima WF840 Front Load Washer / Dryer:
"turn the machine on while you press the start and on buttons at the same time until dOFF..."
"the usual problem with tripping is the heater of the dryer box has become loose and..."
Anonymous posted an answer for this Hotpoint WMA74 Front Load Washer:
"the spring may have gone in the latch on the door. close the door and push the handle part..."
Anonymous posted an answer for this Washing Machines:
"Yes. you'll need to take the bottom rear panel off and remove the retainer from the rubber..."
"the dryer filter is in the dryer box on top of the drum, under the lid of the machine at..."
"you need to remove the outer retaining ring which is a wire around the lip of the seal..."
"turn the machine on whlile pressing the start and on buttons at the same time.hold until..."
"there is a blockage. to get the water out put the end of the drain hose into a basin lower..."
"turn on while pressing the on and start buttons at the same time until 'dOFF' appears."
"the spring will go so that it pushes the latch part in towards the outside edge of the..."
"you can have just cold but you will need to have both hoses, (presuming it's hot and cold..."
"your machine may have a 'brushless' motor. but generally hotpoint motor brushes are fixed..."
"f05 is a drainage problem, ther may be something stuck in your pump. its in the back of..."
Anonymous posted an answer for this Hotpoint Aquarius WMA42 Front Load Washer:
"that sounds to me like a water pressure problem. check the hoses aren't kinked and that..."
"may be a blockage causing the water to spin out thru' the draw. check your filter at the..."
Anonymous posted an answer for this Hotpoint Aquarius WD640 Front Load Washer/Dryer:
"there are 2 screws round the back, take these out, lift the front of the lid slightly and..."
"f-01 means there is a motor problem. may be the motor and/or the circuit board that..."
"there is a blockge so the water comes out the way it went in when spinning, check the..."
"may need reprogramming of the eeprom on the control board. can only be done by engineer..."
"the filter is attached to the bottom of the drum, take the panel off the rear bottom and..."
Load more activity...
31,834 people helped
View all achievements