Press enter to search.
rogerpaul3 posted an answer for this Raypak Pool & Spa:
"Check voltage to the gas valve and make sure it is getting 22-30 bolts when the gas valve..."
rogerpaul3 posted an answer for this Pool & Spa:
"Clean pump basket out and make sure suction lines are not clogged. If all is clear check..."
"Spaguts.com sells a shell repair kit that will work.you could also try an acrylic repair..."
rogerpaul3 posted an answer for this Zodiac Duo Clear System Chlorine Generator:
"Clean cell with 4:1 water:acid mixture to keep it from scaling up."
rogerpaul3 posted an answer for this Zodiac Pool & Spa:
"The cell is dirty or it has failed. Clean with 4:1 water:acid mixture and then check the..."
rogerpaul3 posted an answer for this Jandy Pool & Spa:
"I side the heat pump will be a small temp sensor mounted on the side of the inside area...."
"The cell is bad or the cord is damaged. Look at the middle plate in the cell and you'll..."
"It keeps the clock time.if the power goes out."
"Make sure you have the correct version pda and antenna. The new 18 function white/black..."
"Internal bypass rarely goes bad. More likely the high limit switches have corrosion on..."
"Test wires with a volt meter. You if you have 110-125 volts between white and black then..."
rogerpaul3 posted an answer for this Pentair Pool & Spa:
"Open the doors on the heater and look for signs of rodents. If it looks like rodents have..."
"If the heater fires but shuts down after a few seconds then it's not recognizing flame and..."
rogerpaul3 posted an answer for this Jacuzzi Pool & Spa:
"Impeller may be broken or clogged. Turn the pump off and remove the basket. Reach back..."
"AGA is a symptom of a bigger problem. Its like check engine light for the heater. First..."
"Ignore David, replace the backwash valve."
"Replace it. They aren't really fixable."
rogerpaul3 posted an answer for this Pool Pump Pool & Spa:
"C = common
L = low
H = high
Green or green/yellow stripe always goes to ground.
"AFS stands for air flow switch meaning the heater doesn't know if the fan is working. If..."
"It's a reversing cycle to help free it if stuck. It's normal."
"eo1 error code indicates temp sensor failure. Replace temp sensor. If problem persists..."
"Control board is likely shorted out and needs to be replaced."
rogerpaul3 posted an answer for this Hayward Pool & Spa:
"The sensor is easy to replace with Phillips screw driver and adjustable wrench or wrench..."
"Test phosphates and maintain below 500 PPB. Add additional chlorine if pool is being used..."
"Test continuity between f1 and f2 on ignition control module when the fan is supposed to..."
"Shaft seals leaking. Consult owners manual for shaft seal and replace."
"The pump is not communicating with the control system. Check the comm wire and make sure..."
"Check skimmers baskets and filter pump baskets to make sure there is no flow obstructions...."
"Try a tool repair shop in your area."
"Return the pool to the store or buy an underwater vinyl patch kit."
Load more activity...
26,019 people helped
View all achievements