I treat people the way I would want to be treated.
Scott Frye posted an answer for this Denon AVR-2802:
"Check you manual for a System reset feature ( probably near the back of the manual If..."
Scott Frye posted an answer for this Denon AVR-3805 Receiver:
"Besides the possibility of high volume listening levels , what are the loads ( in ohms)..."
Scott Frye posted a question about Denon AVR588 Receiver:
"ALL inputs and outputs work but it acts like it's all muted"
Scott Frye posted an answer for this Marantz SR7007 7.2 Channel 4K and 3D Pass Through, Networking Home Theater Receiver with AirPlay:
"Check your manual Probably in the back pages If you dont have one , go here ..."
Scott Frye posted an answer for this Audio Players & Recorders:
"On some of the Marantz 22XX receivers you need to pull all the screws that hold the Front..."
Scott Frye posted an answer for this Marantz 2270 Am/fm Stereo Receiver:
"If you have a DC meter , connect it GENTLY across the meter leads and set to 10 or 20 volt..."
Scott Frye posted an answer for this Marantz Vintage Model 2220b Stereophonic Receiver:
"Many of these "Suggested answers " dont line up with the question. 1. Make sure you have..."
Scott Frye posted an answer for this Audio Players & Recorders:
"I own a model 640...BUtton is OUT for stereo. IN for mono"
Scott Frye posted an answer for this Denon DP-29F Turntable:
"Why was the cat carrying your turntable?"
Scott Frye posted an answer for this Audio Players & Recorders:
"We will need more info on what the problem is with this one Thanks"
Scott Frye posted an answer for this Kenwood KD-291RC Turntable:
"The belt has either broken or fallen off try..."
Scott Frye posted an answer for this Audio Players & Recorders:
"1, CD must be upside down in the cartridge 2. if that doesnt help then the LENS itself..."
Scott Frye posted an answer for this Technics SL-PD8 5-Disc CD Changer:
"power supply failure The small amplifiers that send the audio to the output connectors..."
Scott Frye posted an answer for this Audio Players & Recorders:
"Do you have the ground wire for the Turntable attached to the ground screw on the amp? It..."
Scott Frye posted an answer for this HHB Radius 50 Tube Amplifier:
"If you are not a tech , take to someone who is please. One or more output transistor has..."
Scott Frye posted an answer for this Audio Players & Recorders:
"The BIAS circuit may have failed and is allowing the power tubes to max out over their..."
Scott Frye posted an answer for this Crown MT 1200 2-Channel Amplifier:
"trying to bridge TWO separate Macrotechs is not a good idea. If you talked with the..."
Scott Frye posted an answer for this Peavey CS 1400 Amplifier:
"According to PEavey 2 ohms is ok for a load. Are any Clipping LEDs lighting when the..."
Scott Frye posted an answer for this Behringer EUROPOWER EP2500 Amplifier:
"Find a tech that can fix tvs or guitar amps or stereos. Have them replace the swollen..."
Scott Frye posted an answer for this Behringer EUROPOWER EP2500 Amplifier:
"You have at least one power amp module that has failed. The entire module will need..."
Scott Frye posted an answer for this Sansui Audio Players & Recorders:
"Different receivers have diff tuner sections. They dont match for pickup. Buy an FM..."
Scott Frye posted an answer for this Sansui Classic Vintage 2000a Stereo Receiver:
"That series Sansui uses jumpers ( on the rear panel) to connect the pre-amp portion of the..."
Scott Frye posted an answer for this Technics Audio Players & Recorders:
"Dan's right . Find a TV or stereo tech and let them know the issue"
Scott Frye posted an answer for this Denon AVR-2106 Receiver:
"It's not a speaker issue Your optical circuit is faulty. It's probably one board..."
Scott Frye posted an answer for this Onkyo TX-SV454 Receiver:
"Take the speaker wire from the left side and try it on the right side. IF the right side..."
Scott Frye posted an answer for this Onkyo TX-8511 Receiver:
"IS there a MUTE function on the receiver? Is it still barely audible using headphones?"
Scott Frye posted an answer for this Onkyo Audio Players & Recorders:
"1.Always connect TWO speakers to the main output 2. check to make sure you have cross..."