Press enter to search.
Michael Prior posted an answer for this Hayward Pool & Spa:
"The 24v is called the secondary and sometimes called the out-put. Make sure you have 240v..."
Michael Prior posted an answer for this Pool & Spa:
"You can pick your model and purchase any part you need at this..."
"Call a qualified electrician. More information would be needed to accurately trouble shoot..."
Michael Prior posted an answer for this Pentair Pool & Spa:
"The pump is running at prime speed at start-up. Your highest speed (number on panel) might..."
"After 30 minutes of use, feel the outside of the breaker that is tripping. If you feel..."
Michael Prior posted an answer for this Raypak Pool & Spa:
"Heater cool down is very important and needs to be done. A time clock with a firemen..."
Michael Prior posted an answer for this Jandy Pool & Spa:
"One of your actuators more likely the suction side is bad or the toggle switch on the..."
Michael Prior posted an answer for this Sta Rite Pool & Spa:
"Check the control wire that might be connected to the control fuse. If that wire is open..."
"Maybe the temp sensor. Disconnect the sensor and see if it gives a code."
"I had same issue yesterday in the field. The sensor was bad in my case. After replacement..."
"MAKE SURE YOU ARE CONNECTING YOUR PUMP TO A GFCI BREAKER. If unsure call a pro.
"It is very likely that your exhaust Fuselink is faulty. There are two types of fuselink..."
"Try changing the Thermal Regulator. You could just remove the T/R as a test and replace as..."
"At 8 years your SFS sensor could be going bad. Changing the sensor is very easy and not..."
"Check the condition of your filter. Blockage in the filter will cause your issue.
"The fuse link is a device that will open when over heated. If the exhaust temp is to high..."
"Your Pentair VSP should not be connected to any Hayward-Goldline control of any kind. Not..."
Michael Prior posted an answer for this Pentair Mastertemp Heater:
"Make sure you have water flow. 40 gpm is your required flow rate, if you are not connected..."
"Check for mice."
"If you do not have automation connected the board may be having an issue. If you heater is..."
"Every pool and spa combo can be a bit different. When the "OFF" is across the pipe that..."
Michael Prior posted an answer for this Jandy Air Energy Heat Pump - 100,000 Btus:
"Low refrigerant or a bad sensor. Need a pro to look at it."
"After you check the orifices on the heater for spiders check the vent on you supply reg...."
"Your unit is more than likely going into Defrost mode. The defrost sensor is mounted to..."
"The low temp device is mounted inside the intake down below. Remove the large panel at the..."
"Buy your self two new sensors, they are both the same. If your system if reading sensor..."
"If this is a problem only when the air temp out side is cooler than normal and your water..."
"Make sure your water filters are clean and if you have an external by-pass, make sure it..."
"You may only need a defrost sensor. Unfortunately the issue you are having can also be..."
"need more info"
Load more activity...
60,113 people helped
View all achievements