Mark Bean posted an answer for this Goodman Heating & Cooling:
"If the unit is older than 10 years old, I would recommend a new unit. You CAN replace the..."
Mark Bean posted an answer for this Heating & Cooling:
"Try this..."
Mark Bean posted an answer for this Heating & Cooling:
"unfortunately no. It is a communication error so the board would need replaced. If the..."
Mark Bean posted an answer for this Heating & Cooling:
"35/5 dual run capacitor"
Mark Bean posted an answer for this Goodman Heating & Cooling:
"Trap has gone dry on the indoor unit drain or no trap is installed. If trap is present,..."
Mark Bean posted an answer for this Inverter Heating & Cooling:
"Here is a great video to help you with this communication..."
Mark Bean posted an answer for this Heating & Cooling:
"Buy this hard start kit. It has a nice manual inside that tells you how to do it as well..."
Mark Bean posted an answer for this Goodman Heating & Cooling:
"If the status light is completely off then you have a failed board. Also the root cause..."
Mark Bean posted an answer for this Heating & Cooling:
"if you go to this web site they have breakdowns and manuals..."
Mark Bean posted an answer for this Heating & Cooling:
"Generally there is just one filter to clean on these units."
Mark Bean posted an answer for this Heating & Cooling:
"H3 is compressor overload protection. This occurs either during very high load..."
Mark Bean posted an answer for this Mitsubishi Heating & Cooling:
"Check the code to see what that one means. The codes are on the inside of the indoor unit..."
Mark Bean posted an answer for this Washing Machines:
"Sounds like a clutch problem to me."
Mark Bean posted an answer for this The Kitchen Appliances - Others:
"we preheat to 350. Then cook for 3.5 mins per lb."
Mark Bean posted an answer for this Motorcycles:
"You did not give the model number of the particular maddog that you have but this is the..."
Mark Bean posted an answer for this Office Equipment & Supplies:
"I do not believe there is a reset button on this unit. Unplugging it from the power outlet..."
Mark Bean wrote a tip for Heating & Cooling:
"When asking questions on HVAC units or issues with heating and cooling equipment, we will..."
Mark Bean posted an answer for this Bryant Heating & Cooling:
"This model can use a generic contactor providing it is rated for the amp load of the..."
Mark Bean posted an answer for this Heating & Cooling:
"https://www.worcester-bosch.co.uk/support/literature/download/ZKLIT82400 This is the..."
Mark Bean posted an answer for this Rinnai Heating & Cooling:
"The link below is for a great natural gas option, but also has a LP gas alternative. I..."
Mark Bean posted an answer for this Soleusair Heating & Cooling:
"Check the evaporator drain and make sure it is not clogged or holding water in the..."
Mark Bean posted an answer for this Heating & Cooling:
"This could be caused by many things. Some mini-split units run the fan at low volumes all..."
Mark Bean posted an answer for this Dimplex Heating & Cooling:
"R-407C"
Mark Bean posted an answer for this Heating & Cooling:
"https://rinnai.co.nz/Download/ProductFile?encid=Uuiwc6tx4rSunUmdBoJZFkIcRx8SJn..."
Mark Bean posted an answer for this Bryant Heating & Cooling:
"That is a infinity system control. It has solid-state technology and has a small battery..."