Press enter to search.
keith jones posted an answer for this Fisher and Paykel Washing Machines:
"this normally a transducer fault in your main board,board will need replacing"
"what reason do you have to remove the whole top, or did you mean the lid ?"
keith jones posted an answer for this Washing Machines:
"whole top screws need to be removed usually two at the top front and two at the rear,..."
keith jones posted an answer for this Ovens:
"most likely a faulty element or a wire has come off"
"usually there is two power feeds to the elements,so one feed does two elements,you would..."
"normally do not have separate fuses only the house ones,but there are thermal cut..."
"most doors are removable and able to be pulled apart"
keith jones posted an answer for this Smeg Ovens:
"faulty element usually situated behind back panel circlling the fan"
"faulty oven thermostat, replace it"
keith jones posted an answer for this Bosch Washing Machines:
"check the board fuse with a multi meter"
keith jones posted an answer for this LG Washing Machines:
"Check pump for restriction, undo cap at lower right hand side at the front and check for..."
keith jones posted an answer for this Whirlpool Washing Machines:
"faulty cold water solenoid is most likely the problem"
"need more info"
"usually a faulty (blown ) element"
"check that both top and bottom elements work, if a thermowave then the element which is..."
keith jones posted an answer for this Daewoo Refrigerators:
"mostly likely worn out compressor motor"
keith jones posted an answer for this Freezers:
"yes lower number means lower temperature"
"check that the thermostat probe inside the oven has not been moved to close to the upper..."
"there are so many types would need more info"
"the drain hose may be kinked therefore restricting draining of the water or the pump..."
"if its a top loader then a faulty motor controller.(computer main board )"
"that is a sizing problem ,if neither board has been replaced recently,then faulty board"
"could be seized bearings try manually turning the drum"
"the most common problem is the motor brushes have worn out,so motor needs to be removed..."
"panel shorted out"
"possibly a faulty thermal sensor"
keith jones posted an answer for this Hotpoint Ovens:
"fuse under rated or a blown element in one of the stoves"
"would need more info"
"each element switch controls the heat to that element so those switches need to be..."
"would suggest blocked or faulty cold water solenoid"
keith jones posted an answer for this Samsung Washing Machines:
"If all the water has drained the most common fault is the brake motor which releases the..."
Load more activity...
154,232 people helped
View all achievements