kaleidosc551 posted an answer for this Cars & Trucks:
"4 most common causes of engine light on -oxygen (O2) sensor -loose fuel cap -very cold..."
kaleidosc551 posted an answer for this Computers & Internet:
"It's never too late to pay. Companies appreciate integrity, and reward those who try to..."
kaleidosc551 posted an answer for this 2006 Hyosung MS3 125:
"Hyundai 2.0T has a problem with coolant routing through the engine. The holes for the..."
kaleidosc551 posted an answer for this 2002 Harley Davidson FXD Dyna Super Glide:
"I would not suggest going more than 10mm over factory. In this case 110/90 19. Any..."
kaleidosc551 posted an answer for this 2005 Honda CB 750:
"It's either at the starter, or the solenoid. Starter fails if dirt or corrosion are on..."
kaleidosc551 posted an answer for this 1987 Honda VT 1100 C Shadow:
"Move the VT1100s handlebar's until the clutch master cylinder is level or as close as you..."
kaleidosc551 posted an answer for this 1998 Suzuki VS 1400 Intruder:
"Bleeding the clutch is similar to bleeding brakes, only easier. Take the lid of the..."
kaleidosc551 posted an answer for this 1998 Suzuki VS 1400 Intruder:
"Check for lubrication...or a lot more things are going to get harder to use.....clutch..."
kaleidosc551 posted an answer for this Harley Davidson Motorcycles:
"Sounds like you may be low on oil. Bike runs until oil is pumped on top of engine, and..."
kaleidosc551 posted an answer for this Motorcycles:
"A single bolt with a cotter pin holds the rear wheel on the axle, covered with a plastic..."
kaleidosc551 posted an answer for this Motorcycles:
"Wheels generally have two bearings, one on each side of the wheel. There are tools to..."
kaleidosc551 posted an answer for this Motorcycles:
"Each section of the manual should have an exploded view of that area, example engine,..."
kaleidosc551 posted an answer for this Motorcycles:
"Wear suspenders, and hook onto a truck mirror whenever you can. Try to avoid low riders..."
kaleidosc551 posted an answer for this Motorcycles:
"You mean bearings? I get all mine from the bay. You can google your make and model,..."
kaleidosc551 posted an answer for this 2007 kawasaki Ninja ZX10R:
"Check for foreign items in the air intake. Leaves, label off air filter, old..."
kaleidosc551 posted an answer for this Yamaha Motorcycles:
"Regular engine oil is suggested, but since these bikes are not ridden in snow, use a..."
kaleidosc551 posted an answer for this 2007 Tank Sports Touring 150 Deluxe:
"You'll have to remove the plastic around the ignition switch. There should be 3-6 screws..."
kaleidosc551 posted an answer for this Motorcycles:
"Throttle accelerates as sprung cable goes around right side handle. If it is pinched by..."
kaleidosc551 posted an answer for this Honda Motorcycles:
"First, check the fuel filter. It will be in line and accessible from the bottom of the..."
kaleidosc551 posted an answer for this 2002 Harley Davidson FXD Dyna Super Glide:
"Remove seat. Disconnect battery. Undo two bolts at rear of battery box. Push down on..."
kaleidosc551 posted an answer for this 2007 Derbi Atlantis Bullet 2t:
"Without pushing the ignition key in when turning it left from off position, lift the back..."
kaleidosc551 posted an answer for this 2006 Hyosung MS3 125:
"Both front and rear brakes have identical style bleeder valves, and each corresponds to ..."
kaleidosc551 posted an answer for this Honda Motorcycles:
"It should actually have bolts at the shocks, which hold the centre in place. Might be two..."
kaleidosc551 posted an answer for this Motorcycles:
"Purple is hot. If black is used, it is always ground. Hope that helps."
kaleidosc551 posted an answer for this 2003 BMW R 1150 RS:
"Tire pressure, check oil, put can of seafoam fuel treatment in first tank of gas, will..."
kaleidosc551 posted an answer for this Triumph Motorcycles:
"Halfway is actually normal in range for liquid cooled bikes. Gauge may have previously..."
kaleidosc551 posted an answer for this Yamaha Motorcycles:
"It looks like the lens screws are under the fender, but you might have to remove the..."
kaleidosc551 posted an answer for this Bajaj Motorcycles:
"It's the right size tire for that machine. I would suggest removing the fender (4 screws..."
kaleidosc551 posted an answer for this Motorcycles:
"Remove muffler. Remove plastic cap over axle nut. Cotter pin holds axle nut on, use pipe..."
kaleidosc551 posted an answer for this Motorcycles:
"That hard click when you shift into first can be due to not letting the bike warm up..."