Id have been a brain surgeon if not for wanting to have 100 careers and not just one.
brett meldahl posted an answer for this Welding Tools:
"The only things that come to mind after your checks are a spool not set in completely, a..."
brett meldahl posted an answer for this 2007 Chrysler 300:
"Which v8?"
brett meldahl posted an answer for this Chrysler Cars & Trucks:
"Sounds like the radiator has an integrated transmission cooler (very common) and theres a..."
brett meldahl posted an answer for this Cars & Trucks:
"Yanmar TNV Cylinder Head Bolt Torque TNV82A Step 1 = 30.0 Nm Step 2 = 61.7..."
brett meldahl posted an answer for this International Box Cargo Van - 4700 Dt466e - Truck:
""
brett meldahl posted an answer for this Stihl Garden:
"Its an old enough saw that the gasket in the case could need replacement. Uts the 1st..."
brett meldahl posted an answer for this 2008 Toyota Camry:
"Step 1 Slide the two front seats forward. This may not be necessary, but it will give you..."
brett meldahl posted an answer for this Kenneth Cole Watches:
"They all set pretty much the same. Here is the general walk through from the Cole..."
brett meldahl posted an answer for this Ford Cars & Trucks:
"Number Description 1 Ignition relay 2 Windshield..."
brett meldahl posted an answer for this Cars & Trucks:
"On the Mercury Milan, the fuel pump shut-off switch is located in the front passenger..."
brett meldahl posted an answer for this Star trac Exercise & Fitness:
"Removing the magnet isn't necessary. If you just adjust it all the way back from the..."
brett meldahl posted an answer for this Coffee Makers & Espresso Machines:
"--As with many things ran by electronics these days, unpkug for a few minutes to let the..."
brett meldahl posted an answer for this Samsung Washing Machines:
"So first make sure you have proper and contact current in the outlet being used. A simple..."
brett meldahl posted an answer for this Dodge Cars & Trucks:
"Can you send me a picture, please? I just did a reinventory of my storage and I think I..."
brett meldahl posted an answer for this Cars & Trucks:
"Check all battery connections. Make sure they're clean and tight. Make sure any extra..."
brett meldahl posted an answer for this Hand Tools:
"Don't drill, don't cut, don't do anything u til you take a picture of the fastener and..."
brett meldahl posted an answer for this Saturn Cars & Trucks:
"Out of box bad replacement thermostat, thermostat is backwards, bad water pump, failing..."
brett meldahl posted an answer for this Mazda Cars & Trucks:
"Lightly tighten the four (4) 10mm bolts, with no thread locker, because using thread..."
brett meldahl posted an answer for this Cars & Trucks:
"From engine front to back theyre numbered 1,2,3,4. Firing order is 1-3-4-2. Front of the..."
brett meldahl posted an answer for this Exercise & Fitness:
"First it always helps to post a make, model and serial when you can. You have what is..."
brett meldahl posted an answer for this Precor 9.21 Treadmill:
"worn running belt and deck. You can try to clean the belt a bit using a clean towel and..."
brett meldahl posted an answer for this Precor Efx-5.33 Elliptical Machine Cross-trainer Fitness Exercise Equipment 833:
"bar soap on the ramps where the wheels travel until the shine wears off the wheels. I see..."
brett meldahl posted an answer for this Precor Efx-5.33 Elliptical Machine Cross-trainer Fitness Exercise Equipment 833:
"I imagine if 106 people have responded then at least one may have asked if the squeak is..."
brett meldahl posted an answer for this Precor 935 Premium Series Treadmill:
"If you have a known good speed sensor (reed switch) and you have tested it with an ohm..."