Benjamin Schollmeier posted an answer for this Mazda Cars & Trucks:
"I would first check for loose wheel bearings, or loose or frayed abs wire connections or..."
Benjamin Schollmeier posted an answer for this Mercury Cars & Trucks:
"Usually this is a failed SRS sensor. This is the impact sensor that triggers the airbags..."
Benjamin Schollmeier posted an answer for this Kia Cars & Trucks:
"find the transmission oil pan. It may have a drain plug on it. Drain it measuring how..."
Benjamin Schollmeier posted an answer for this Ford Cars & Trucks:
"I have to ask.. why would you want to do that? It's quite annoying."
Benjamin Schollmeier posted an answer for this GMC Cars & Trucks:
"This is almost certainly a failed hood sensor."
Benjamin Schollmeier posted an answer for this Cars & Trucks:
"Check compression to start sounds like there is a loose connecting rod or bearing. which..."
Benjamin Schollmeier posted an answer for this Cars & Trucks:
"an arm and half a leg"
Benjamin Schollmeier posted an answer for this Cars & Trucks:
"Try cleaning out the throttle body. Surprisingly this can confuse the car pretty bad if..."
Benjamin Schollmeier posted an answer for this Cars & Trucks:
"Auto parts stores sell a quick disconnect tool. Pretty cheap. ask them how to use it they..."
Benjamin Schollmeier posted an answer for this 2003 Chevrolet Tahoe:
"check bulb? Sounds like a failed control switch"
Benjamin Schollmeier posted an answer for this Cars & Trucks:
"A failed crank sensor will do that yes."
Benjamin Schollmeier posted an answer for this Cars & Trucks:
"Low coolant?"
Benjamin Schollmeier posted an answer for this 1998 Nissan Altima:
"Sounds like a failed alternator to me. The alt powers everything when running. If failed..."
Benjamin Schollmeier posted an answer for this 1992 Subaru Loyale:
"I'm thinking this is a broken wire issue to the rear. Pull the switches out in the rear..."
Benjamin Schollmeier posted an answer for this Cars & Trucks:
"This is usually due to a failed srs impact sensor. They trigger airbag deployment in a..."
Benjamin Schollmeier posted an answer for this Cars & Trucks:
"replacing the evap purge solenoid should fix this problem"
Benjamin Schollmeier posted an answer for this 2007 BMW X3 3.0si:
"I would check the spark plugs and wires or coil packs. Sounds like the ignition system is..."
Benjamin Schollmeier posted an answer for this Nissan Cars & Trucks:
"Not sure on this vehicle.. but check near the crank pulley has to be near there sometimes..."
Benjamin Schollmeier posted an answer for this Cars & Trucks:
"Near the crank shaft pulley. sometimes behind the timing cover depending on vehicle."
Benjamin Schollmeier posted an answer for this Cars & Trucks:
"I would start with checking the spark plugs and cleaning out the throttle body."
Benjamin Schollmeier posted an answer for this Toyota Cars & Trucks:
"I would start with checking spark plugs and cleaning out the throttle body."
Benjamin Schollmeier posted an answer for this Fiat Cars & Trucks:
"I would run out of life and die listing how many things could cause that. Start with..."
Benjamin Schollmeier posted an answer for this Cars & Trucks:
"Check for loose or noisy wheel bearings. Check for loose or frayed abs wires. Check for..."
Benjamin Schollmeier posted an answer for this Mercury Cars & Trucks:
"Check spark plugs"
Benjamin Schollmeier posted an answer for this 2000 Chevrolet Cavalier:
"Check fuel pressure and spark"
Benjamin Schollmeier posted an answer for this 2006 Saturn ION:
"I would first clean out the throttle body. If it gets dirty the IAC valve (idle air..."
Benjamin Schollmeier posted an answer for this Cars & Trucks:
"If the temp gauge reads in the middle, nothing to worry about. Engine coolant normally..."
Benjamin Schollmeier posted an answer for this 1988 Ford Bronco II:
"turn the ignition key to on."
Benjamin Schollmeier posted an answer for this Chrysler Cars & Trucks:
"Likely the crankshaft position sensor is intermittently failing. When it fails the engine..."
Benjamin Schollmeier posted an answer for this BMW Cars & Trucks:
"fuses, relays if there are any, motor, wiring, switch.."
Benjamin Schollmeier posted an answer for this 2008 Audi Q7:
"Because the battery went flat. Most likely need a code from the dealership to make the..."