Andy posted an answer for this Heating & Cooling:
"At any home depot"
Andy posted an answer for this Heating & Cooling:
"It doesn't matter. It will still work ,diesel is still consider a gas"
Andy posted an answer for this Heating & Cooling:
"You need a multi meter that could read mfd to test capicator. Most of the time a blown..."
Andy posted an answer for this Trane 3 Ton 13 SEER R-410A Heat Pump Condenser XB13:
"Check to see if condenser fan running . If fan running then you have a dirty coil."
Andy posted an answer for this Heating & Cooling:
"You cannot mixed refrigerant .System will not work right"
Andy posted an answer for this Heating & Cooling:
"You have dirty coil .just clean it out with water"
Andy posted an answer for this Heating & Cooling:
"You have a bad thermostat"
Andy posted an answer for this Honeywell Heating & Cooling:
"What does 2 flashes mean ?. Maybe the controller is bad"
Andy posted an answer for this Lakewood Heating & Cooling:
"Is it 120 volts or 220 ?. If 120 then connect the black or red to power and white to..."
Andy posted an answer for this Dayton Heating & Cooling:
"Look at the panel and it will tell you what the flash code mean . I THINK it mean roll out..."
Andy posted an answer for this Honeywell Heating & Cooling:
"Where was the jumper on the old thermostat .Was it from R to Rc"
Andy posted an answer for this Refrigerators:
"Is your evaporator fan working. If yes then you may have a bad thermostat or a bad defrost..."
Andy posted an answer for this Heating & Cooling:
"Your system is overheating, check for air flow restriction"
Andy posted an answer for this Heating & Cooling:
"Is this a new install ,if yes then sound like it is not wired right"
Andy posted an answer for this Panasonic Heating & Cooling:
"You may have a dirty coil so unit shuts off on high head pressure. Turn unit off and..."
Andy posted an answer for this Heating & Cooling:
"If it is made for 120 volts then it would not work on a 230 volt .For it to work you have..."
Andy posted an answer for this Montgomery Ward Heating & Cooling:
"Look for any HVAC supply house around your area, they should have it"
Andy posted an answer for this Dayton Heating & Cooling:
"A safety is holding out the main gas valve from opening when call for heat ,check all..."
Andy posted an answer for this Heating & Cooling:
"Sound like the furnace is working as design"
Andy posted an answer for this Carrier Heating & Cooling:
"That is a 5 ton RTU"
Andy posted an answer for this Heating & Cooling:
"Is this a high efficiency furnace with pvc leading outside. If yes check to see if unit is..."
Andy posted an answer for this Heating & Cooling:
"You may have dirty coils"
Andy posted an answer for this Goodman Heating & Cooling:
"Maybe you have a welded contactor"
Andy posted an answer for this Heating & Cooling:
"Why do you want it to cycle on emergency heat if heat pump is working . In a heat pump..."
Andy posted an answer for this Heating & Cooling:
"Bad or dirty thermocouple"
Andy posted an answer for this Heating & Cooling:
"You may have a bad thermocouple."
Andy posted an answer for this Montgomery Ward Heating & Cooling:
"You should call a experience technician for this because there could be several things..."
Andy posted an answer for this Heating & Cooling:
"Red goes to R and white goes to W"
Andy posted an answer for this Heating & Cooling:
"What kind of unit you have ?.Is it a heat pump with electric heat?."
Andy posted an answer for this Coleman Heating & Cooling:
"Was it doing the same thing before you replaced the sequencer ,if yes then replaced it..."
Andy posted an answer for this Heating & Cooling:
"There could be a lot of issues here .Just call a technician to look at it"