2will fix anything with a plug
Denny Adams posted an answer for this Dyson DC14 Animal Bagless Upright Cyclonic Vacuum:
"Cheap plastic parts. trade it in on a good vacuum like panasonic"
Denny Adams
Denny Adams posted an answer for this Hoover SteamVac F5914-900 SpinScrub Upright Vacuum:
"dried soap in tubing. clean them out"
Denny Adams
Denny Adams posted an answer for this Electrolux Vacuums:
"check hose for clogs"
Denny AdamsDenny Adams posted an answer for this Shop Vac Vacuums:
"hot plastic. the motor bearings are bad"
Denny AdamsDenny Adams posted an answer for this Kenmore Vacuums:
"sears parts on line"
Denny AdamsDenny Adams posted an answer for this Rainbow Vacuums:
"Relace them"
Denny AdamsDenny Adams posted an answer for this Dyson Vacuums:
"get rid of it. Dyson is a piece of junk from the gitgo. over 20 years in the vac repair..."
Denny AdamsDenny Adams posted an answer for this Hoover Vacuums:
"replace the belt, or the roller may be frozen"
Denny Adams
Denny Adams posted an answer for this Ridgid 40128 WD1680EX 16 Gallon Wet/Dry Vac With Detachable:
"No more than any other vac"
Denny Adams
Denny Adams posted an answer for this Oreck XL Shield Power Scrubber Floor And Carpet Cleaner:
"Oreck is junk, despite the ads. trade it in on a Royal and yuu problems are over. been in..."
Denny AdamsDenny Adams posted an answer for this Oreck XL Shield Power Scrubber Floor And Carpet Cleaner:
"this is a piece of junk. trade it in on a royal"
Denny AdamsDenny Adams posted an answer for this Vacuums:
"screw it back in COUNTERCLOCKWISE with a little glue on it"
Denny AdamsDenny Adams posted an answer for this Hoover Vacuums:
"replace the pulley"
Denny AdamsDenny Adams posted an answer for this Miele Vacuums:
"could be as simple as a broken belt or a clogged hose run a broomhandle through it or a..."
Denny Adams
Denny Adams posted an answer for this Bissell Powerforce 13" Brushroll 6582 6583 3530 3537 46E5 71Y7:
"there is likely a broken cam inside.replace it"
Denny Adams
Denny Adams posted an answer for this KitchenAid K45SS Classic Stand Mixer:
"take off the chrome ring around the rotator. remove the screws that were hiding under it...."
Denny Adams
Denny Adams posted an answer for this KitchenAid KSM90 Ultra Power Series Stand Mixer:
"kitchenaid parts on line, try mixing smaller batches of dough"
Denny Adams
Denny Adams posted an answer for this Dyson DC07 Bagless Upright Cyclonic Vacuum:
"its a dyson......get rid of it"
Denny AdamsDenny Adams posted an answer for this Singer Vacuums:
"try cleaning the ends of the brush roller. thread gets caught in there and jams it"
Denny Adams
Denny Adams posted an answer for this Dirt Devil M085805 Upright Vacuum:
"likely the belt is crooked, and jammed in the floor plate. try reseating it."
Denny AdamsDenny Adams posted an answer for this Kenmore Vacuums:
"most likely your bearings are shot. it will need a new motor"
Denny Adams
Denny Adams posted an answer for this Oreck XL21 Bagged Upright Vacuum:
"you probably have a broken belt. replace it"
Denny AdamsDenny Adams posted an answer for this Vacuums:
"Squeeze the sides of the lamp cover, and it will snap off. then you will see 2 screws..."
Denny Adams
Denny Adams posted an answer for this Euro-Pro EP055 Bagged Canister Vacuum:
"find a sew and vac store in your yellow pages"
Denny AdamsDenny Adams posted an answer for this Hoover Vacuums:
"this is a left handed thread you mite have to hold the other end of the shaft twith a pair..."
Denny Adams
Denny Adams posted an answer for this Kenmore 34720 Upright Vacuum:
"sounds like one of two problems 1 it may not be seated properl2 the bearings in the motor..."
Denny Adams
Denny Adams posted an answer for this Eureka Altima Upright Vacuum Model 2996AVS Vacuum:
"it slides in to a channel on the top of the bag compartment"
Denny Adams
Denny Adams posted an answer for this Kenmore 22812 Bagged Canister Vacuum:
"likely a belt or broken wire in the power head"
Denny AdamsDenny Adams posted an answer for this Miele Vacuums:
"find a vac repair shop in your area or google VDTA and they can direct you"
Denny Adams
Denny Adams posted an answer for this Hayden Industries SuperVac 6000 Central System Vacuum:
"one of two problems cause this. first is a short in the wires that turn it on, the small..."
Denny AdamsDenny Adams posted an answer for this Vacuums:
"its likely clogged somewhere"
Denny Adams
Vacuums 89 answers
Coffee Makers & Espresso... 11 answers
Sewing Machines 7 answers
Food Mixers 4 answers
Heating & Cooling 2 answers
Microwave Ovens 2 answers
Irons 2 answers
Cars & Trucks 1 answer
