Zapco Answered Questions & Fixed Issues

Do you work here? Claim your company

  • 23 Products
  • 33 Answers
  • 13K Views

Try their website or a youtube video.

Zapco Car Audio... | Answered on May 29, 2016 | 232 views


If it goes into protect and your speakers and wires are good, chances are you have bad output transistors that will need to be replaces.

Zapco Reference... | Answered on May 16, 2014 | 329 views


are you sure you didnt wire the amplifier the front and rear to
left/ right?

check your deck settings to see that the rear speaker rca are connected.
check all wires are connected.
push the mono or bridge buttons are off.

provide more info.

Zapco I-450... | Answered on Nov 15, 2013 | 49 views


Go to this link and see page 47

http://www.zapco.com/files/Download/DCRef.pdf

Zapco Reference... | Answered on Jan 20, 2013 | 47 views


4-channel, 4 ohms: 4 x 50 Watts
4-channel, 2 ohms: 4 x 90Watts
Stereo, 4 ohms: 2 x 180 Watts
T.H.D. : Frequency Response: 10 - 25KHz
S/N Ratio: >90dB
Channel Separation: >50dB
Dimensions: 13"L x 9.9"W x 2.25"H

Zapco I450 Zapco I 450 iForce Series 4 Ch. 360 Watt Amplifier

Zapco I-450... | Answered on May 23, 2011 | 195 views


i got a wiring paper that comes with the peq plug,its not a manual but it shows how to wire up a zapco peq

Zapco Car Audio... | Answered on Dec 04, 2010 | 712 views


check your settings on your stereo and the amp make sure you have changed to 1 ohm on the amlifier for a briged connection to a subwoofer and change from lpf to hpf on the amp there should be a switch.

Zapco Reference... | Answered on Jun 08, 2010 | 162 views


Storing as in Distortion? If that's the case lower the output gain from your amp until it is suitable to you ears. It might be all the way open, besides this should be adjusted system to system.

Zapco Reference... | Answered on May 31, 2010 | 73 views


If the amp uses TIP35Cs and TIP36Cs, those will be the output transistors. Measure the resistance between legs 2 and 3 for each of the output transistors. Do any read near 0 ohms?

If you're new to repairing amps. The following page should help.
http://www.bcae1.com/repairbasicsforbcae1/repairbasics.htm

Zapco Reference... | Answered on Nov 18, 2009 | 518 views


If your car battery was not disconnected when the amp was installed them your amp has blown, it could just be a fuse or at worst the circuits inside have fried. Check your fuses if not take it to a certified car audio shop and ask them to have a look at it for you. Need more information to help you bruv, but from what you have said it has been connected with the car battery still connected

Zapco 1100M Car... | Answered on Sep 18, 2009 | 115 views


Hello michaelandta,

Check your filter settings on the front channels. It sounds like they may be set to "high pass" which would eliminate the bass frequencies. If you are using the amp to power normal speakers, it's usually best to set the filters for "full range". If the amp only has "low pass" and "high pass" settings, turn them both OFF.

Hope this helps.

Zapco I-450... | Answered on Sep 12, 2009 | 116 views


the left and right clips are for your subs to tell your amp that they are not going to (flatline) clip which is when you start to lose clarity and get distortion

Zapco C2K-3.0X... | Answered on Jul 05, 2009 | 70 views


check connections, fuses could be due to a poor connection.

does it have a thermal cut out?

Zapco 1100M Car... | Answered on Dec 15, 2007 | 111 views


Check your ground and make sure it is properly grounded ....it needs to be a very clean paint/gum free area tightly bolted.  Next Check and make sure you are recieving your 12 volts (not running)  13 (running)    by placing your test leads from positive to ground...... then make sure your power remote from your head unit is putting out voltage. 

Zapco Reference... | Answered on Oct 13, 2007 | 281 views


Go here first http://www.zapco.com/ Good Luck

Zapco C2K-9.0XD... | Answered on Aug 06, 2006 | 273 views

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Zapco Experts

Ronny Brite
Ronny Brite

Level 3 Expert

655 Answers

Robert Rankin

Level 2 Expert

378 Answers

Lawrence Oravetz

Level 3 Expert

10548 Answers

Are you a Zapco Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...