ZAGG Computers & Internet - Answered Questions & Fixed Issues

search for one on google

try to blow with compressed air, for cleaning it for dust and other small pieces

is it plugged in ? Did you install the software

CAN I UPGRADE PROCEESSOR TL 56 TO TL-60 IN HP PAVILLION DEFINE MOTHER BOARD BASE 8/16 OR 32/64 IF 32/64 THEN ONLY I CAN CAN CHANGE CPU TL-60 OTHER WISE NOT ABHINANDAN KUMAR JAIN [email protected]

Try this: http://cfprod.zagg.com/downloads/ZAGGkeys/pocket/Pocket_Generic_US%3ACAFR%3ASP_032015_ONLINE.pdf If that is wrong, look here: https://www.zagg.com/us/en_us/support/owners-manuals

Need new keyboard or try cleaning out with compressed air.

Mine went dead after about 3 weeks. Once I realized there was a charging port which is not IPhone, but droid type. Began charging. Would not recognize until I went to blue tooth setting and said forget device. Then turn bluetooth on and then hold bluetooth key down on for 3 seconds or so on keyboard. Then it worked. I guess dont let it run till it dies.

I recommend a technical expert to do this. It is the proper way.

Any charger with a micro USB connector will do. Not sure where in the world you are so just google MicroUSB charger

This is the direct download link to the manual: http://cfprod.zagg.com/downloads/ZAGGkeys/FOLIO/ZAGGkeys-FOLIO-Instructions-Galaxy+Note-8-082913.pdf

READ THE MANUAL.

Check the manual or the website.

Did you check the Logitech website and forums ?

IMHO, best way to know is to try using it while charging...

Electronics dont do very well when they get wet. i would take it apart and dry it out with a hair dryer. All you have to do is take the screws out on the back and pop the 2 halves apart. You do have to be careful. once it;s apart you will see why it was;nt working. good luck

let you finish a sentence

I am having big black same problemalthough none of the numbers are showing up in my contacts either or my clock???

Don't forget to switch on bluetooth. Then look under devices if your keyboard comes on the screen. It could be the device is asking for you to type in a code like 0000 or 1234. Or whatever. Only when you did pair the device to your iPad, it will be able to see the keyboard when you switched it on.

I'm having the same problem as a lot of people are. II saw a lot of silly answers like clean the keyboard, as if all those many Zagg keyboard owners have dirty keyboards right out of the box. This is a buffering issue, you can see it. The Zagg will skip a letter that you type, then double insert it in the next word as if its trying to catch up. This is a buffering issue.

If your keyboard has a removable battery, perhaps try change it. If you do USB charging, make sure that it is not connected from a hub. In desktops, direct USB ports can be found from the rear and it is where you get more power (~450 mA) to charge the battery.