Yamada Recent Questions, Troubleshooting Help & Support

Contact your remote control manufacturer

hello i am the owner of a dvr-9300hx recorder and i need the driver can you send me have a probleme with it thank you for your help

im looking for in too

HelloThe remote controls for Yamaha are very difficult to get from open electronic spare part market; and is very difficult to synchronise with other universal remote controls. Even though it can be synchronised with any universal remote controls, all functions will not work properly.So it is best to get an orginal one. Contact the Authorised Service Center for Yamaha at your town. They can provide you the orginal one. The cost will be a little bit more, but original is original. OK.

Hi Mark,
If you have necessary tools and test instruments, know safety precaution in basic troubleshooting try the steps below to solve your problem.
Assuming that the disc is good.
1.Clean the lens. - Sometimes because of dust the lens can't read any disc. Try clean the lens by soft cotton buds. Be careful while doing this.
2.Check the ribbon - Check the ribbon connected to the lens from the main board for scratch, damage. Once it has an open line then of course the lens can't read the disc. Also try to erase the contact by pencil eraser. If you've done the steps above and the symptoms still there then the next step requires you a little knowledge in soldering technique and reading the ohmmeter.
3.Check the Spindle motor - Check the motor that spin the disc with an ohmmeter. You can test it using the ohmmeter (x1) even it is connected on the lens assembly.Good motor - reading should be fairly high and it will spin. Bad motor- reading will drop to low resistance and will not spin.
Hint : 50% of my repaired unit the above parts are commonly caused of the problem.
If you confirmed that you have a defective motor then replace it with a new one. Before replacing the new motor you have to check the clearance of the disc holder with the old one. The clearance should be the same as the old because if not the lens will not read the disc if it is too far or too close.
If the above steps didn't cure the problem, high chance that your optical lens was faulty.

If you can't do the job yourself, I would advice you to look for a professional to troubleshoot the symptom.

Hope I helped you.
Have a nice day!
Thanks for using Fixya.

Hello,

the X2 button cannot be removed when it is pressed, it will certainly remain on the screen of your TV because that's how it was made.

But you can try this, look for OSD (on screen display) on your remote, if you find it, press it severally, and if doesn't remove it, then there is nothing you can do.

Good luck.