Wolf Range Ovens - Popular Questions, Answers, Tips & Manuals


Dear Friend,
Pull the oven towards you, disconnect any electrical cord from the wall. Normally the fuse is located right next where the electrical cord enter in the back of the stove. If there is any panel right on top of where the electrical cords connects to the oven, simple removed that cover and there should be a fuse. If not, removed the rear panel where the electronic control panel is. Hope you can find it!

Good Luck!

Wolf Range Ovens | 208 views | 1 helpful votes


you proably have an element out

Wolf Range Ovens | 392 views | 0 helpful votes


A plastic putty knife can help, but the logo is held on with double sided tape and the Wolf parts book always says to order a new logo whenever you order anything that requires removing the logo

Wolf Range... | 336 views | 0 helpful votes


I had a Wolf 30F wall oven with a similar problem
after power outage. It wouldnt stop beeping with error message related
to temperature control. My solution was to turn power of at circuit
panel, then reset by pressing and holding the clear button for 5
seconds.

Also note: in my case I had to close the display
before switching the panel off. When I tried to the reset process with
the panel showing, it wouldn\'t reset.



To reset other
various parts of the control panel Instructions said:



Time-of-Day Clock

Immediately after the oven is installed, set
the 12-hour clock to the current time of day. It may need to be reset
after a prolonged power failure. The clock is visible on the control
panel during all modes. If the upper oven timer is set, the clock will
not be visible in the upper oven control panel display.



SETTING CLOCK

1) Touch CLOCK.

2) Touch number pads to
set current time of day.

3) Touch CLOCK or ENTER to start
clock.



24-HOUR CLOCK

The time-of-day clock can be
changed from a 12-hour clock to a 24-hour clock. After the clock has
been set, touch TEMPERATURE for three seconds, touch CLOCK, and then
touch ENTER. Follow the same sequence to change back to the standard
12-hour clock setting.



Fahrenheit to Celsius

The
oven can be changed from Fahrenheit (°F) temperature to Celsius
(°C).

Wolf Range Ovens | 803 views | 0 helpful votes


screw is next to the pilot tube where it attaches to the safety valve. unscrew to find the actual adjustment

Wolf Range... | 309 views | 0 helpful votes


Most ovens have BAKE, BROIL and yours might have CONVECTION. Turn each on independently. If all don't work its one problem if only one doesn't its another
Also is it the gas doesn't ignite or it ignites then no temp change (or electric gets to xx degrees but doesn't get hotter?

Wolf Range... | 407 views | 0 helpful votes


Hi

This means a loose/broken wire on the oven temp sensor or the oven temp. sensor itself is bad and should be replaced. To solve this issue test the oven temp. sensor, it should read between 1080-1120 ohms, if the rating is more then that and the door appears to be closing fine then it is the control board that is bad and should be replaced. Hope this helps...please post back for further assistance.
Daniel

Wolf Range Ovens | 459 views | 0 helpful votes


pilots set to high

Wolf Range... | 144 views | 0 helpful votes


i have original papers on those ovens... and can fix them

Wolf Range Ovens | 85 views | 0 helpful votes


Hi

The issue can either be a bad electronic control/clock assembly or the oven temperature sensor (probe) has gone bad. To solve this issue start by checking the oven temp. sensor for 1100 ohms, if the rating is more then that then check the control and door switch and replace the part that is bad. Hope this helps...please post back for further assistance.

Daniel

Wolf Range... | 119 views | 0 helpful votes


YOUR OVEN,S POWER SWITCH IS SHORT,TRY REPLACING IT.

Wolf Range Ovens | 396 views | 1 helpful votes


Hi,


If your electric oven is taking too long to heat or just not heating up right, then check out this tip that will give more detail about your problem.

Oven Problems Electric Oven is Heating Slowly or Poorly

heatman101


Wolf Range Ovens | 621 views | 0 helpful votes


heres about the cheapest solution to try goto www.marcone.com under contact us there is a 1800 number this is the cheapest appliance parts dealer and the largest in the world .Yes you can replace the ignitors and the leads would be termed as harnesses not quite sure what you are refering to switches that sit on top of gas valves though do you have a site or a picture also send your model number as well and when you goto marcone just get a quoted price from them and then check wolf as well the manufacturer if you have any further questions message me back and please remember when our chat has concluded to rank how this opinion has helped Thanks again Rick

p.s about the most reasonable path would be to take out the ol multimeter and assure that you have the same amount of voltage going to each ignitor in most ovens this is controled by a spark modulator you can also remove each ignitor and do continuity tests on them to assure they are functioning properly as well remember to message me back your model number

Wolf Range Ovens | 192 views | 0 helpful votes


Hi,
Here is a tip that I wrote that will help figure out why the burner spark keepson clicking...

Gas Range RepairBurners Keep on Clicking
heatman101

Wolf Range Ovens | 1,150 views | 1 helpful votes


If you can hear and see the spark lighting that acually means there is no gas entering. please check that you have have the pilot knob in possition and and and the pilot pibe and orifice is not blocked with dirt.

Wolf Range... | 363 views | 0 helpful votes


is the pilot lit?

Wolf Range... | 186 views | 0 helpful votes

Not finding what you are looking for?
Wolf Range Logo

69 questions posted

Ask a Question

Usually answered in minutes!

Top Wolf Range Ovens Experts

Harjeet s. bola
Harjeet s. bola

Level 2 Expert

49 Answers

ray gallant

Level 3 Expert

70761 Answers

jenifer ronan
jenifer ronan

Level 1 Expert

11 Answers

Are you a Wolf Range Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...