Whirlpool Heating & Cooling - Page 5 - Recent Questions, Troubleshooting & Support

On the circuit board there is a micro relay that is stuck in the closed position. Or it is wired so that the sensing ability (thermostat) controls the comp and it is stuck closed

most fan motors have a solnoid to start or stop them the compressor uses the capacitor

Could be a valve problem or freon needs to be topped up.

if it works with batteries installed then it will do just as the buttons declare. if not then take it to pep boys to see if its outputting infrared signal or point at a camera an watch light

Bhanu & Sethu's reply works very well, i found white button to reset. Thanks, umesh

go to www.ask.com or to www.wiki.org /how to fix e4 enter if any one else has had this issue there will be a record of it and an answer on how to resolve the issue. you mite try www.youtube.com with the same question see if anyone done a video on the problem thank you rod

Hey, Back -on line , & the answer to your question is ...go to webpage or type in whirlpool model window unit mod acq189! This equals to 17,800 btu 15 amps 220 volts 3 speed.

The light flashes after a certain amount of run time. It is a reminder to check the filter to see if it needs cleaning. Once you have checked/cleaned the filter and reinstalled it, press the filter button for 5 seconds and the light should go out.

your problem is the heating element is burnt out. This can be caused by a number of problems the most common is debris getting past the filter and accumulating on the heating coil causing a burn out. The heating coil sits behind the evaporator coil so you will need to remove the a/c from the casing. Once this is done you will see the heating element . If you are able to do this repair you will see that it is fairly simple. The element actually looks like the element in a toaster. Remove the wires from the element unscrew the element from the a/c case taking it and the model and serial #'s to an appliance supply for replacement. If you aren't in the mood to mess with it an a/c tech won't charge an arm and a leg to do this for you it's usually the cost for the part and a slight labor charge. Good Luck on your repairs hope this helped

Dave

WHAT IS THE MODEL #???

Front bottom panel ( under ) door is removed to expose pump clean out access points lint , loose change, tooth picks Exeter. Also attached ither to top, front bottom or rear access pannel is a electrical schematic with decoder and test guide.... please do not attempt with out tools and electro mechanical experience .especially if under warranty . Ie call for service if in over your head...