Whirlpool Dishwashers - Popular Questions, Answers, Tips & Manuals


either full water sensor bad or water solenoid stuck open

Whirlpool... | 12 views | 0 helpful votes


https://www.youtube.com/watch?v=eUD0HMC0OvI

https://www.hunker.com/13407814/what-causes-a-whirlpool-dishwasher-to-have-a-flashing-light

Whirlpool... | 57 views | 0 helpful votes


https://www.youtube.com/watch?v=l8GFXlVGY-8

Whirlpool... | 53 views | 0 helpful votes


When the dishwasher starts to make funny noises or working loudly, it is usually because there are debris caught in the draining pump, although a problem with the motor is also possible.

Drain Pump: The drain pump might needs to be checked for debris. If its clean and noisy it needs to be replaced.

Circulation Pump: Bearings inside the circulation pump will wear out over time and can cause a loud groaning sound while the dishwasher operates.

Wash Impeller: The wash impeller has small plastic blades that help with water flow to the control arms. If one of the blades breaks there could be a noise. It may also be improperly aligned. Inspect for any signs of damage.

Source: https://www.electrafixbc.ca/appliances/dishwasher.html

Whirlpool... | 112 views | 1 helpful votes


All dishwashers are "tall' now. But will fit under counters wiring diagrams are glued to the inside of the panels

Whirlpool... | 81 views | 1 helpful votes


Video at the link below suggests it may have a locking feature:

https://m.youtube.com/watch?v=XAauYps8k5E

Whirlpool... | 102 views | 0 helpful votes


i don't know. as it is new, i would call the seller or the manufaturer to see if this a normal condition or if a free service call is necessary.

Whirlpool... | 130 views | 0 helpful votes


Where is it leaking from? It'd it is under the door, check the door gasket for tears.

Whirlpool... | 153 views | 1 helpful votes


Please check your normal water supply it's above 35'c no need to contact any component

Whirlpool... | 122 views | 0 helpful votes


cycle timer. Mine wouldn't shut if timer were in the wrong place.

Whirlpool... | 158 views | 0 helpful votes


Are you sure the cycle is complete?
If it is drying dishes then you will be interrupting the cycle. It is possible to cancel cycle and start over.

Whirlpool... | 131 views | 0 helpful votes


It appears that the model number you gave is incomplete. Please check again and then perhaps you'll get some more answers.

Whirlpool... | 189 views | 0 helpful votes


Your water will not get hot because your control board since there is no water been coming into the dishwasher and turn the heater off you need to run the diagnostic mode fix the problem and that should take care of the issue

Whirlpool... | 145 views | 1 helpful votes


Try unplugging it and wait 30 seconds plug it back in and it should reset the computer

Whirlpool... | 117 views | 0 helpful votes


There is a sequence to reset. Firstly open the door then press heated dry normal heated dry normal within three seconds of each other

4_23_2019_6_06_58_pm.png

Whirlpool... | 85 views | 1 helpful votes


My whirlpool dishwasher gold GU2475XTVQ0 had rapid blinking lights that started with the "4 Hour Delay" LED and changed to others when other buttons were pressed. The machine would not run. I followed the instructions located behind the kick panel and verified the keypad was the issue and not the control circuit by elimination.
The big surprise for me was that when I used a straight pin to resistance check all of the buttons, they checked out OK. I reconnected the 14 pin connector (P1) to the control and found that the buttons/LEDs were behaving correctly! I believe that pushing the straight pin into the 14 pin connector removed any corrosion in the 10 year old device and permitted the keypad to communicate with the control again.
I reassembled the dishwasher door and it ran with no problems. I was ready to replace the keypad for $150, but didn't have to!

Whirlpool... | 1,609 views | 0 helpful votes


Some dishwashers have soft food disposals. If something gets in this disposal that will not dissolve such as bone, pop corn kernels, broken glass. This will make noise throughout the cycle. Sometimes after many cycles it will grind itself away. Otherwise service would be needed if you don’t know how to get inside the pump.

Whirlpool... | 70 views | 0 helpful votes

Not finding what you are looking for?
Whirlpool Logo

7,024 questions posted

Ask a Question

Usually answered in minutes!

Top Whirlpool Dishwashers Experts

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

Mike

Level 3 Expert

4369 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Are you a Whirlpool Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...