Waring Kitchen Appliances - Others - Recent Questions, Troubleshooting & Support

Waring would be a possible source.

Waring Kitchen... | Answered on Dec 24, 2019

If it is a removable cord, you will get one in a good electrical shop, or online by describing the connector.

If hard wired, you can buy a plug with wire attached at home depot and fix it yourself by removing the place where the wire goes in.


This shows the model. It has a special bespoke connector

You can get a new, used on one for 20 bucks.

Waring Kitchen... | Answered on Jul 09, 2019

The reset can trip if there is a short circuit or the unit is over-heating. Either condition is dangerous. Unless you can locate the problem, for safety reasons suggest replace the entire unit with a new one.

Waring Kitchen... | Answered on Apr 23, 2019

Linkco perhaps. That may be a general supplier.

Waring Kitchen... | Answered on Jan 19, 2019

Kudos to the person(s) that identified the safety switch on the housing. Mine would not turn on because the switch would not depress, perhaps the plastic insertion piece on the frame was a little off. I tried wedging aluminum foil and plastic etc, but if you don't depress the black button in the middle of that white shroud on the switch exactly right, it won't work.
My solution was to permanently attach a 1/2 inch deck screw thru the housing so that the screw tip keeps the switch depressed always.
Turn the unit on its left side, use a very small bit to make a pilot for your screw. Very carefully and slowly screw down until the tip activates the switch. I don't believe there is a circuit board or anything in the vicinity, and I left mine plugged in so I would know when I hit paydirt. Caveat emptor and good luck!

Waring Kitchen... | Answered on Dec 22, 2018

go to fastenal hardware or any store that sells hardware to match one up

Waring Kitchen... | Answered on Dec 19, 2018

continue beeping there is a sensor or switch not normally operate. How to Fix by open you waffle maker assembly.
wwm450pc_(costco)_ww_1-qooiw4fc5lrzbika4rggwo4o-1-9.gif Trace the switch that causes beeping

Waring Kitchen... | Answered on May 03, 2018

Heating element or control failure

Waring WMK300... | Answered on Apr 19, 2018

The elements usually aren't removable. The inside is a cassette. Access is from screws at the bottom.

Waring WCT702... | Answered on Feb 19, 2018


Lever for toaster will not stay down

After taking the toaster oven apart to check why no voltage was applied to the circuit board for the electromagnet coil that holds the rack during toasting operation, I find this unit uses resistive voltage from the outside right heater assembly. The connection at the rear is very fragile and will fail when operated. The repair I used is an eye type electrical connector, crimp type, with a copper wire inserted before crimping the heater wire into the terminal. Use a small ***** with nut to attach back to the connection.(#4x1/2x32) I also used silver bearing solder to create a better connection to the ***** and board connector. 7 cents for parts, 15 minutes to actually repair once the condition was found. Not bad on a $100 toaster. Time will tell on the sustainability of the repair, but has run multiple cycles so far.

on Dec 29, 2017 | Waring Wto150 4-slice Toaster Oven...

Try Googling (waring)(w0508)(manual) without parens.

Waring Kitchen... | Answered on Dec 26, 2017

Try Googling (waring)(PS101)(manual) without parens.

Waring Kitchen... | Answered on Dec 12, 2017

Not finding what you are looking for?
Waring Logo

344 questions posted

Ask a Question

Usually answered in minutes!

Top Waring Kitchen Appliances - Others Experts


Level 2 Expert

158 Answers

Ps Daengr
Ps Daengr

Level 1 Expert

24 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Waring Kitchen Appliances - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides