The red protect light is coming on
It is possible that your amp is going over the threshold limit of draining current to give out the protect signal. What could be done is to first checkout if your speakers are loading the amplifier, check the rating of the speakers and the impedance, must not be too low.below 2 ohms. Now check the source signal if this is bringing in any transcient signals to power out the outputs particularily high/low freq. So decrease off your bass and treble to mid position and test again. see if there is any improvement, if so there could be a filter problem with your set. Connect an external source and see if the amp powers better , in such case check for fault in cables, input lines and ground with in the set. Repeat this and check. Hope this helps you out. Good day
Hand held wont work
I had what sounds like the same problem two different times. The first time the ground wire at the 12 volt to the FM modular the bolt where it was connected to the chase was loose I tighten it and the controller worked. The second time it was the in line fuse on the same 12volt to ground. The fuse is inside a two inch long black case on the same ground wire. Good luck let me know if that's your problem.
Jena.
Not finding what you are looking for?