Vector Vehicle Parts & Accessories - Page 5 - Popular Questions, Answers, Tips & Manuals
Can i replace battery on veco12pob and how
Most are made in away where it is possible.Locate the screws that hold the 2 exterior shells together and reove all of them. the shells should part easily enough and it is matter of just matching the batery inside and then doing the physical swap. you may have tape and padding holding it in place in one shell, so you need to match it on reassembly. then reassembly is just the reverse procedure of the disassembly.
1/1/2012 6:42:48 PM •
JUMP START...
•
1,564 views • 1 helpful votes
Would like to purchase
Call Schmacher at 1-800-524-3880 and they can set you up with a replacement. Don't be shocked at the shipped total cost. You just might want to
Your power pack will tell you what voltage wall charger you need. Where you plug one in, it will show 12v, 17v...etc. Yours is probably 12v. On the right side of the connection hole, if you see a + sign, your pack requires positive polarity when you attach an adapter. You can find universal power adapters with an adjustable output and various tips that is sure to work well with your pack. All tips will have a + sign on one side and a - on the opposite side. Just make sure you put the correct side of the tip (- or +, depending on what's on the right side of charging hole on your pack) on the same side of the wall adapter's wire connector end that has the word TIP on it or some other demarkation.
I wish you the best of luck.
9/7/2011 2:06:05 PM •
JUMP START...
•
780 views • 2 helpful votes
I have a Vector VECO12C.
I have the same problem and finally found out the internal battery was bad. Having a terrible time trying to locate one
8/31/2011 3:35:44 PM •
JUMP START...
•
425 views • 0 helpful votes
I am trying to use my start-it pro system for the
When a question is presented to any forum, model number(s) are essential. Please provide any that you have and if you would. Just to make sure I'm fully understanding what you're asking, would you please rephrase your question?
A lot of models don't come with an AC/DC wall charger and it must be purchased separately but I'm fairly certain there is an alternate method to charge your unit. I'll be able to specifically determine how, once I have the model number.
FYI: The VEC070 1.5 Amp Automatic Charger is a commonly used charger for this type of jump-start system. Don't buy anything until we're certain.
9/8/2011 1:50:22 PM •
JUMP START...
•
249 views • 0 helpful votes
Lost charging plug. Where
Don't sweat the power plug, white power coming outta the unit is a
Huge problem.
You need to call these folks,IF YOU SHOULD EXPERIENCE A PROBLEM WITH YOUR
PURCHASE CALL TOLL FREE (866) 584-5504. IN MOST
CASES A SERVICE REPRESENTATIVE CAN RESOLVE YOUR
PROBLEM OVER THE PHONE.
The white powder is a sign of battery leakage. If you keep it in your trunk, that white powder will digest almost anything it has prolonged exposure to. Handle with gloves. Good Luck!
Manual link:http://www.baccusglobal.com/bd/manuals/NEW%20MANUALS%20FOR%20WEB/VEC012POB%20MANUAL.pdf
9/16/2011 1:25:50 AM •
JUMP START...
•
114 views • 0 helpful votes
I have a veco 13.
Can you please check the make and model #. The make and model # did not bring anything up in my system.
Thank You
7/17/2011 6:00:54 PM •
JUMP START...
•
355 views • 1 helpful votes
Not finding what you are looking for?