Valor Toys - Recent Questions, Troubleshooting & Support

give me your adress an I send you a [email protected]

I can't tell what kind of appliance you're talking about.... but, here's what I know.. This "lever" you're talking of kind of stumps me, but try, after the gas lights, to hold the lever in the position you had when you lit the flame. Hold it on for about a minute... then release it... and see if the flame will remain going. If you can't keep the flame going "no matter what", you probably need to clean or replace the flame sensor.

The parts are available available online from heatmasters but they are about 70 pound.if your stuck I could get you one for 30 pounds plus postage.

No, I have mine in manual mode, then hit the red (off) key and large flame key ( top right) at the same time. You should hear a click followed by a series of clicks as the pilot light turns on and then the gas valve opens and it should light. Having said that, I happen to have two that were installed at the same time. Unfortunately one has a bad remote control. I found that out after switching and syncing the remotes to the other insert. The good remote works on both and the bad one on neither. The bad remote would not let me set the time.

the user guide can be download here:

http://www.partsarena.co.uk/baxi/System/DATA/Dx/DS1/user/4332/U14-4332/U14-4332.htm#zfuelbedrefittingceramicpebbles

I have an AF16N. You just turn the knob and light with a match. Do you have a user manual? I'm desperate for one - willing to pay!!! Have had to disconnect the fire until I find a manual.PLEASE contact me on [email protected]

If a flame will ignite, then the pilot, thermocouple, valve, etc. is all good.
If it has a piezo electric ignitor, that usually works from pushing a button.
You should hear a snap from a spring, and see the arc.
If you don't, then the piezio electric ignitor is probably bad.
But if the control is just a rotary knob and no push button, then this is one that has to have power run to it, or a pilot light.

Have you tried changing the 9V battery under L side panel?
That's what was wrong with mine.

Cheers