Univex Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 26 Products
  • 25 Answers

There's a Carriage Arm Knob that has to be loosened that could be a possibility also your supposed to lubricate it weekly with mineral oil.

Univex Duro 7512... | Answered on Sep 26, 2015

the retaining pin wears causing it to stick inside the shaft ,best thing i can think off is to leave it alone as it could run forever like this,trying to drill it is useless without a diamond drill bit as the pin is hardened steel ,possibly in excess of 60 rockwell C .As and when it shears then its easy to remove but hammering it will only welt the end making it jam in even harder .The motor could burn out before it wears away or a bearing go ,the only way to remove it is a press as this will not damage the end too much ,unless their is a secondary cotter pin locking this one in

Univex Food... | Answered on Apr 12, 2014

I must assume that you confirmed power at the outlet by plugging in a hair dryer or some other type of appliance. If the outlet works the failure in your Kitchen Aid mixer could be a failed speed switch, motor or a loose wiring connection. In order to diagnose the failure will require dis-assembly and checking voltage, the wiring and switch operation using a volt/ohm meter.

Univex SRMF20... | Answered on Jul 30, 2011

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Univex Experts

Earnest Bowes

Level 2 Expert

234 Answers

Ned C Cook
Ned C Cook

Level 3 Expert

3433 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you an Univex Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides