Tunturi Cycling - Answered Questions & Fixed Issues

a set of micrometers will tell you the shaft size

https://www.youtube.com/watch?v=AbNSTg0HrAA https://www.youtube.com/watch?v=wGSrQlZp22g

I think that the chain is not in the right direction so you should put it in the right place.

To access the battery compartment, first undo the 4 screws from the underside of the regulating panel. Remove the cover. Turn the panel upside down. Press down while pulling the lid off the battery compartment. Now you can replace the 2 AA batteries. Use care not to damage the insulation on the lead when you replace the panel. This is shown in the manual for the Tunturi Ergometer W2 on page 5. The manual is available on the Tunturi support page: https://www.tunturi.com/en/manuals/ . After clicking the link to Download User Manuals, I used the search function to get just the manuals with W2 in the title. My browser history gave the link as http://tunturi.o.auroraobjects.eu/Tunturi%20W2_User%20Manual-1.pdf?AWSAccessKeyId=1S7UGFX3CSD93G0EE549&Expires=1552955026&Signature=b6TOgHUkRLZrP1EdPBDyHtxVEfc%3D . I hope this helps. Cindy Wells

Unless it is 40 years old the pads are not Asbestos.

all pedal will fit this bike go to a bike shop

1990

either chain is off or drive gear is so dry the dogs wont move, probably chain off.

this like any machine needs some maintenance, please tighten screws and oil a little , turn it over and see if something is rubbing.

open it up and oil the chain a little , tighten pedals

batteries plus or ebay

need new pedals, they screw off and one if left hand thread and one is right hand thread. or unscrew both over the top to the rear.

here it is! http://www.fitnessrepairparts.com/diagram/7213

oil works best, 2 - 5 drops in the top of the cable housing and it will make its way down. don't use more than that just let it work. might actually drip out bottom so might want to put a towel under it.

have you tried fitnessrepairparts.com

hi,
I have added a link here i think it will give you some help.
http://www.cybexintl.com/support/maintenance/techtips/CleaningAndMaintaining530Bikes.aspx

ok

Type in your browser: PTS Turbo 1000. That will show up all the available shops or internet shops where to get it.

Could be that the belt is sliding against the wall of the wheel (against the ridge/lip). This is because your wheel is probably not level. This is usualy caused by wear, or because the wheel was moved or adjusted on purpose and not levelled or aligned correctly.

A 1: If your wheel is not level, the belt going around the wheel will inevitably migrate towards the edge of the wheel stand in front of the machine and look straight down at the wheel while it is motion (spinning), you should be able to see if it (the belt) is moving.

If, however your wheel is bent, this could cause the same problem. However, this is no quick fix. It will generally mean replacing the wheel

A 2: In order to recognize if your wheel is bent, stand in front of the machine and look straight down at the wheel while it is in motion. You should be able to see a, "Wobbling" in the wheel, indicating its condition.

kjk

It looks like the only cable FitnessRepairParts has for Tunturi Ergometers is a speedometer cable for serial numbers greater than 474100.