Tsunami Car Audio & Video - Recent Questions, Troubleshooting & Support
Signs of a blowed 15 inch subwoofer
Melted voice coil? Short circuited voice coil due to overload? does your amplifier work properly? Is the (-) properly grounded? If the SUB is in working condition and there is nothing wrong with the amplifier. 1) The amp is not powerful enough to run the sub2) The amp is not properly grounded or powered3) Remote Sensor wire is not connected4) RCA Cables or Hi - input sensors are not connectedCheck out the installation to verify or the sub may be damaged
The voltage meter stays on an there is a flashin
the LCD meter will stay on until voltage in the car stabilizes, and you will notice that if u hit the power unlock button it will turn back on after its off..
do you have it hooked up correctly?
I Usually run power from battery to + of capacitor then another wire from positive of capacitor to amp, Then you can run ground from amp to capacitor negative then anotheer wire from cap - to a good ground
I was given a tsuname 2 farad
It doesn't matter...Just make sure your negative and positive terminal hookeups are correct. (as in, don't connect a positive wire to a negative terminal).
Help with code radio for my nissan pp2787h
The radio code is a security feature that's meant to deter theft, and it's unique to each vehicle. If you've lost your code, you'll need to contact a Nissan dealership or service center and provide proof of ownership. They should be able to help you retrieve the code. Please do not attempt to use codes from the internet as incorrect attempts may lock your radio.
Is there bluetooth on nsdn-w59
I have the same radio now with no Bluetooth am trying to get Bluetooth on it too without having to buy another radio. Please help.
No sound from wireless headphones in a toyota sienna
First thing to do is check to make sure that the batteries are properly charged.
Second, make sure that you have a clear line-of-site to the IR transmitter. Infrared (IR) works the same way that your TVs remote control works - if the signal is blocked, then you will not hear any sound.
Third, make sure that you are in the rear seat of the vehicle when listening to the sound. The IR transmitter only transmits to the rear seat, so you will not hear any sound if you are sitting in the front seats. This is a common problem that i see.
Lastly, make sure that the heapdhones you purchased are compatible with your 2006 2007 2008 2009 or 2010 Toyota Sienna. Remember that some older models require RF headphones, not IR headphones. I checked http://www.audiovideo2go.com for compatibility before I purchased my headphones. They have a useful listing of all the headphones and models of vehicles they are compatible with.
Not finding what you are looking for?
