Tricity Bendix Washing Machines - Recent Questions, Troubleshooting & Support

I had the same problem. Then I discovered that the Bendix USA WDS1043 / WDC1024 is the same, or almost the same, as a Splendide Comb-o-matic 6000. You can find an extensive parts manual at
http://www.splendide.com/service/Combo_PartsBreakDown.pdf
and an owners manual at http://www.splendide.com/manual_wdc1024m.pdf

I think Splendide is still in business, in which case they may also be able to supply parts for the Bendix WDS 1043 M - check them out at
http://www.splendide.com/

They can also supply a replacement washer/dryer combo when your present unit finally dies.

Good luck with a great washer combo!

Colin

bad heater element or fusible link in manifold

Hi, I have a very similar issue with you guys. My tricity bendix washes ok but doesn't heat up when drying. It's cold. Does anyone know what part I need or how to fix it?

https://www.youtube.com/watch?v=J7vzWGMvfOM

Thermal fuse or high ouput thermostat.

is it plugged in, are water hoses attached, is the lid down? make sure all these are done then select ya cycle and hit the power button.

Most likely..... 1st does it run the exact amount of time when it trip. If so the action that it is about to cycle into has to much of a load on it, or bad breaker. if machine detects a problem it will automatically go 2 zero and let the water out. Also check the board for corrosion

There should be a small hatch on the lower right front of the machine that you can open and access the drain pump. Tricity Bendix AW 1200 Operating Installation Instructions Manual...

Are you leaving the door open when it is not in use? If it is a front loader, you cannot leave the door closed when it is not being used, it will get moldy and smell bad. If this is what is happening, try doing a full hot wash with bleach. It may take a few times to get all of the smell out.