Taylor Refrigerators - Recent Questions, Troubleshooting & Support
1 Answer
External unit on my walk-in cooler will not shut off. Seems to be due to the Ranco Pressure Sensor. How do I fix or adjust?
blog.us
cooler.com/
walk-in-
cooler-freezer-problems/
Jun 7, 2013 - Diagnose Walk-in Cooler & Freezer Refrigeration Problems ... For many evaporator units, the ice isn't melted, or the water isn't .... It works for few days (2-3 days) and it stop and does not run until I shut off the power .... My walk in compressor seems to be running and not shutting off. .... outdoor ambient= 85
blog.us
cooler.com/maintain-
walk-in-
cooler-freezer/
Jan 7, 2015 - Torn gaskets can let warm air infiltrate your walk-in cooler or freezer. Close the door when not in use. Do not block or prop the door open for extended periods of time. ... on suction lines between the condensing unit and evaporator coil. ... Make sure the lights are off when exiting the walk-in. ... clean walkin ...
Refrigerators
|
Answered
on Jan 11, 2021
1 Answer
Hoshizaki ice machine
The machine will continue to run water all the time while in harvest mode. The control board blew, and just needs to be replaced. Controls boards can fry without any other signs of anything else being bad. Hoshizaki ice machines dont have a over heat relay that shuts it down upon oerheating if it is the control board
Refrigerators
|
Answered
on Jan 11, 2021
1 Answer
Water is not flowing into my GSI-23 ice maker.
As the harvest cycle (the ice maker fingers rotate to sweep the cubes out of the mold) comes near the end of the rotation, a switch in the ice maker activates to send power to the water valve (located under the refrigerator where the house water supply line connects) and allows perhaps 4 cc of water to flow up a 1/4" plastic line to a fitting on the back of the refrigerator that is aligned with the ice maker inside which then flows into the maker mold. That process refills the ice maker mold and everything shuts off to freeze this water and then initiate another harvest cycle when the entire process is repeated. If there is no water, then there is no ice. Focus on why the water isn't flowing all the way to the ice maker. Look for an ice blockage in the tubing that comes from the back, inside wall of the freezer to the ice maker, or a bad valve. It is rare, but the switch inside the ice maker could be bad. The water valve or a blocked water line are most likely the culprits. Another trick is to pour water into the ice maker mold, wait several hours and see if that freezes and ejects into the pan. If so the ice maker is working, it just has no water to freeze.
Refrigerators
|
Answered
on Jan 09, 2021
5 Answers
Capillary tube replacement
The True TSSU-60-16 uses an oversized (134A) refrigeration system with air flow directed at the pans.... if the capillary tube is plugged it will NOT cool at all.. most of the time a restriction (plug) is at the drier where the capillary tube goes into it.. as it is smallest passage in the system...hope it helps
Refrigerators
|
Answered
on Jan 09, 2021
Not finding what you are looking for?
