Summit Logo

Summit Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 119 Products
  • 83 Answers

Use the refill cans with a pressure gauge to fill it to the "safe" zone on the gauge. You just don't want to overfill them. Running low is not dangerous, just not efficient.

Summit SCR312L... | Answered on Feb 06, 2019

Google (summit)(CL66FDOS)(manual) without parens.

Summit... | Answered on Jan 13, 2019

Hello Mani,
There are many ways to get money through the internet. In fact, you can kill your traditional day job for a cyberjob. One way is through another way is through
Forex is another avenue. You will have to learn this though. You can check out and start trading micro lots on

Another way is through affiliate marketing selling things like Clickbank Products(, Commission Junction, etc. You can use search engines like Google via Google Adwords or Yahoo.

Others are Paid Surveys and Referrals

There are many ways to make money....depends on which one appeals to you most. Feel free to ask more questions.

Cheers & Have a great day.

Summit... | Answered on Dec 07, 2018


Summit... | Answered on Dec 01, 2018

I could not find a manual for your SPW2201SS, but I did find a manual for a SPW2200SS. (Look for clogged hoses, in and out!) Sadly it only lists three 'error codes' on Page 27 and they include: E10 E21 E31 Summit SPWD2201SS Washer download instruction manual pdf

Summit Washing... | Answered on Oct 28, 2018

The right setting depends on how many door openings the fridge sees in a day and how packed with food it is. If the fridge is warm, try increasing the thermostat slightly to a higher number. Come back 24 hrs later to see if it has gotten better, You may need to do this a few times. If you don't get any results, then it's possible the thermostat is faulty or the fridge has a leak in the cooling system.

Summit... | Answered on Oct 13, 2018

Hi, One of the most common problems with frost-free refrigerators (and often with upright frost-free freezers) is drain freeze up. This is usually caused by the defrost drain clogging, then freezing. On older units, it can also happen when the insulation (usually open-cell Styrofoam) around the drain gets 'water-logged', as it often does over the years, causing ice to build up inside the drain.
The first symptom, at least in top-freezers, is usually water under the crisper drawers, on the floor of the refrigerator section.
In side-by-sides and upright freezers it'll appear as a nifty slab of ice on the freezer floor, eventually running water out onto the kitchen floor.

These are quick and easy to make. Just cut a piece of #12 copper wire (strip from regular 12-2WG 'Romex' household wire) about 6 inches long and bend it around a 1/4 inch round rod. A screwdriver shaft works well for this, but any 1/4 inch dia. piece of metal will do.
Now when your refrig or freezer drain clogs and you find the trough under the evaporator full of ice, here's what you do.
Clear the
ice, open the drain (use hot water in your one gallon pressure sprayer and a wet-vac, and hang this little piece of copper on the defrost heater, so it extends down the drain. On most units, this is a black rod under the evaporator coil. Some use a radiant heater inside a glass tube, with which you can use this method, but you must carefully bend the hook on your copper wire to the diameter of the glass, being sure it puts no pressure on the glass.
This heater is responsible for melting all that frost that we don't have to deal with since the advent of Frost-free units, and it glows a dull red during the defrost cycle, so there's plenty of excess heat for our purpose.
Anyway, since copper's such a good conductor of heat, some of the defrost heater's energy will transfer down the copper wire, into the drain, and keep it open. What I like to call 'stupidly simple', this uses no extra electricity and works extremely well!
One precaution: hang this piece of copper *loosely* over the defrost heater. Don't squeeze or crimp it on, or you risk causing a "hot spot", damaging the heater.
Note: I get a lot of questions as to whether this wire will melt the rubber drain grommet or plastic drain tubing. I've installed literally hundreds of these wires (wish I'd kept count!) and have never seen any damage caused to those areas.
Keep in mind that when the unit switches into defrost, the inside of the freezer is at or below zero. Most defrost cycles last 20 minutes max, with the heater shutting down before the cycle
ends, so the warmth that travels down this little copper wire isn't nearly intense enough to melt anything but ice.

Hope this makes sense! Good luck

Summit... | Answered on Jun 15, 2018

it seems that your washer isn't seated properly. I don't know what type of machine you have but if you could let me know I might be able to help you with your problem. Usually with top loaders you just put your hands on the back of the machine and lift forward toward the front and that should seat your machine but not knowing the type I can't be sure.

Summit... | Answered on Feb 03, 2018

SPWD1800 Manual

Summit SPWD1800 | Uploaded on Dec 24, 2017

It means something is wrong with door lock currently having same problem.

Summit SPWD1800 | Answered on Mar 03, 2017

I would check the website of Summit Photofix Copier for the correct drivers for your device and your OS.

Summit Photofix... | Answered on Mar 03, 2016

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Summit Experts

ray gallant

Level 3 Expert

67952 Answers

Cindy Wells

Level 3 Expert

6101 Answers

Dai Boyce
Dai Boyce

Level 2 Expert

288 Answers

Are you a Summit Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides