Sterling Plumbing - Recent Questions, Troubleshooting & Support


Try this link.
https://s16962.pcdn.co/wp-content/uploads/2017/02/17469_Install.pdf

Sterling... | Answered on Apr 07, 2019


Your fixture body may be corroded beyond repair. Since you've replaced all the rebuildable parts, I'd suggest you get a plumber to check it but expect that you'll need to replace the faucet. Get a modern "cartridge" (Delta, Moen or Kohler) fixture that can be easily repaired indefinitely.

Sterling... | Answered on Oct 28, 2017


One thing you might check is to make sure the spring is installed properly. The small end of the cone should be facing out.Thank you.

Sterling... | Answered on May 19, 2011


Hex set set screw bottom side of handle hub. I see no adjustments... likely you will need to replace the cartridge.

http://structuredflowfaucets.com/wp-content/uploads/2016/12/912090B.pdf

Plumbing | Answered Yesterday


Run diagnostics.

Settings > System > Diagnostics



If no problem found, try System Reset.

Settings > System > Reset > Reset System > Cancel or Reset System

IMPORTANT!Resetting the system will return your interface to the original factory default settings. This will also delete any custom configurations or settings.

Plumbing | Answered 2 days ago


replace the leaking parts

Plumbing | Answered 2 days ago


The market is full of brands making these faucets but how to decide which one is the best suited to your needs. Below mentioned are few things which should be kept in mind while making a purchase of a touchless kitchen faucets.

  • Position of the motion sensor
    It is important to check where the sensor is placed on your kitchen faucet. Their position varies from brand to brand. Some of them come with the sensor installed on their spout, while others have them at the bottom or the top of the faucet. It is up to you to select the one which suits your needs. Moen touchless faucets have two sensors, and the wave sensor is placed at the top which is responsible for the activation and deactivation of water flow and the other sensor, ready sensor is placed at the bottom, which is used merely for identifying the articles in your sink.
  • Power Source
    When it comes to a power source, there are two types of touchless kitchen faucets in the market. For the ones that need a continuous power supply you have to make sure that they are installed near a power outlet in your kitchen. The other type runs on a battery and can be placed anywhere. You can choose either depending upon your kitchen needs.
  • Others
    Before buying the faucet for your kitchen make sure its length, height, etc. is appropriate for your kitchen. Also make sure whether it is easily installable or not.

Plumbing | Answered on Jan 19, 2021


so acquire the instructions from moen and get it done right

Plumbing | Answered on Jan 13, 2021


Every 2-3 weeks, someone or something clogs it.

Plumbing | Answered on Jan 09, 2021


It most likely needs to be primed. Check the owner's manual for instructions.

Plumbing | Answered on Dec 28, 2020


When you next get the smell, check the traps to see if there is enough water in there to fill the trap, if one is less then it looks like water is getting sucked out when toilet is flushed or that trap (usually bath or shower) hasn't had water going in (lack of use) and water has partially evaporated.

Plumbing | Answered on Dec 22, 2020


yea the one you are about to spam us with

Plumbing | Answered on Dec 17, 2020


yes it can if you have hooked it up correctly and as to your additional info ?? and if trying to get more pressure is your cut in and cut iut or the pressure switch set correctly if not all the pumps in the world not going to give you more pressure and if well lines are plugging with debris the same problem

Plumbing | Answered on Dec 14, 2020


The handle and base of a kitchen fixture can work free after some time. A free fixture handle can meddle with the capacity of the spigot to turn on and off proficiently. Then again, a free base can move openly and cause the water lines providing the spigot to burst, causing a break. Fixing either of the two parts will incredibly diminish the aggravation related to a free kitchen spigot.

Eliminate any items in the sink bureau that meddle with your capacity to arrive at the two inventory valves situated at the rear of the bureau. Turn every valve clockwise to kill the stockpile of water to the fixture.

Inspect the fixture handle. You will either discover a setscrew with a recessed hex head at the handle base or beautiful covers snapped on the highest point of the handle or handles. You can also choose a residential plumbing Edmonton to solve your problem.

Plumbing | Answered on Dec 11, 2020


If the old hose isn't leaking, why change it. They discolour internally due to the type of water you have.
Chalky water makes white calcium deposits and soft water more brownish. Perfectly normal.

Plumbing | Answered on Dec 10, 2020

Not finding what you are looking for?
Sterling Logo

3 questions posted

Ask a Question

Usually answered in minutes!

Top Sterling Plumbing Experts

Bill Johnson

Level 2 Expert

306 Answers

Brad Brown

Level 3 Expert

18564 Answers

Tom Chichester

Level 3 Expert

61177 Answers

Are you a Sterling Plumbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...