Speed Electrical Supplies - Recent Questions, Troubleshooting & Support

Engine surge/governor hunting are usually a carburetor issue. First check air filter, drain fuel tank, drain and clean carburetor fuel bowl. Then use fresh fuel from a clean dry fuel can. If its still hunting, check that the carburetor mounting bolts are not loose. If carburetor mount is good, then the carburetor likely needs cleaning or replaced. You could also try SeaFoam or other similar fuel treatment. Just follow label directions, usually 1 oz / gal... measure don't guess.

Increase the speed for constand power output, or check the load it maybe more than the genset can power.

Mybe power from the commercial supply had failed . Or power surge occured and the genset detected power failure. The other cause could be air bubbles in the gasoline.The genset may need bleeding to remove air bubbles in the gasoline.

Sorry but we do not have a parts locator service at this website.

An AC generating set runs at a continuous speed in order to produce current at the correct Hz - 60Hz in the USA and 50Hz almost everywhere else. The built-in governor will maintain the preset speed, opening and closing the throttle automatically as a load is plugged in or removed.

Wiring is incorrect. Sounds like the wiring is in series instead of parallel. http://waterheatertimer.org/How-to-wire-switches.html#triple Gene Water Heater Timers Save Money If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

hurontel on ca

If you are careful and take the hot coming into the fan from the power source and connect it to the colored wires one at a time, you will be able to find which one is high, med. and low. Then connect them. Hot in is L, 1 is low, 2 is med, 3 is high If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c