Smeg Kitchen Ranges - Answered Questions & Fixed Issues

I've got a smeg oven and the center burner won't light the igniter does spark but won't like and I have no idea what's wrong it seems like the gas is not getting to it and I don't

Try cleaning the burner and jets.

Smeg Kitchen... | Answered on Nov 05, 2020 | 14 views

I have a Smeg gas range C30GGXU1 and NONE of the stove burners click to ignite anymore. Any ideas?

Mostly when you can light up the pits without the clicker, then that means that there is no power on the stove at all. Check the power cord running to it (which generate the sparks) and see if there is any damage to it.

Smeg Kitchen... | Answered on Jan 16, 2019 | 128 views

1 Answer

My SMEG gas oven won't stay alight. When I stop pressing the oven regulator the gas goes out.

Check the regulator at your gas bottles may need replacing

Smeg Kitchen... | Answered on Nov 18, 2018 | 583 views

1 Answer

Hi I have a Smeg gas cooker. The gas oven is giving me trouble. It'll ignite and keeps on for a few minutes and then the flame goes out. It takes a few minutes once the oven is lit for the fan to kick in. However if the flame goes out the fan keeps going so you don't know that the flame is out. The fan keeps going for 20 minutes before it stops and all the while you think the oven has been cooking only to find that for the past 20' minutes it's been cooling down. So I have to check every 2 minutes to see if the flame is still on and the oven is still cooking, most times having to relight it, which requires opening the door and holding the knob down for 15 seconds before the flame stays on. It's tiresome and really doesn't work while baking. Please advise?

Most likely the thermocouple faulty. Not sure about the gas regs where you are so be sure tocheck them out before replacment

Smeg Kitchen... | Answered on Oct 16, 2018 | 458 views

1 Answer

I have only had my smeg stove for a month and the flame spreader crowns have stained considerably and I can't get them clean with the recommended cleaning instructions.

even stainless steel will tarnish with the heat from the flame
all metal discolours with heat so the cleaning products will only be to remove spilt food etc from the hob

Smeg Kitchen... | Answered on Aug 14, 2017 | 60 views

1 Answer

Could not find power cable for SUK62CMX5

contact your supplier or manufacturer as it has nothing to do with fixya site

Smeg SUK62CMX5... | Answered on Aug 02, 2017 | 39 views

1 Answer

I have a Smeg Range

It could sometimes be a thermocouple that is not properly mounted against the flame or is just defective, these thermocouples are mounted for safety because it would not be good if gas flows out of gas for a long time without flame in professional gas equipment, the gas flow is often Many times higher, by the way a nice device and good brand.
I think the damage is very common here. By hand, you might also be able to take it yourself if there is technical knowledge and with the proper attention on gas sealing. look a few examples of your problem from of the link about this.
How to change furnace thermocouple

Smeg A1A.1 Gas... | Answered on May 25, 2017 | 916 views

1 Answer

How do I turn off a Smeg Classic591Ss range hood.

Unplug it for now and then try and find a new switch pad.

Smeg Kitchen... | Answered on Sep 28, 2016 | 773 views

1 Answer

Wiring oven programmer timer has extra connector

off hand I would say they gave u the wrong timer - unless there is suppose to be an adapter included

Smeg SUK92MFX5... | Answered on Feb 12, 2016 | 73 views

1 Answer

The appliance is connected E,N2,N1,L2,LG can this be connected directly to the wall supply terminal ie E,N,L

u might want to look at page 8 of this manual
http://downloads.beko.co.uk/bekoupload/manuals/HII64401T.pdf

Smeg SI3644B... | Answered on Feb 12, 2016 | 57 views

1 Answer

Looking for a circuit diagram

It's usually und the console. A Google search on how to remove the console for your particular make will give you specific instructions.

Smeg SUK92MFX5... | Answered on Mar 08, 2015 | 196 views

1 Answer

How do i replace the bulb in a Smeg rangehood?

I WOULD MESS WITH IT TAKE IT TO A GARAGE THAT DO ELECTRIC WORK

Smeg Kitchen... | Answered on Mar 03, 2015 | 378 views

1 Answer

A42C-5 smeg oven, tripping RCD when switched on, flash is seen in top right corner if you are looking at the back of the cooker. what is likely fault

Control board is probably shorted out ?
hope that helps?

Smeg A42C-5... | Answered on Mar 01, 2015 | 95 views

1 Answer

My smeg oven turns itself off in the middle of cooking

Sounds like a sensor is bad. I would call a repairman on this one. Should be a simple and cheap fix.

Smeg 27-Inch... | Answered on Jan 18, 2015 | 394 views

1 Answer

How to set timer

I found a pdf of the manual for your stove. See the link below to download the pdf.
If you press the button that looks like a bell under the clock you can use + an - keys to set the minutes for a reminder timer that won't turn off the oven.
After turning the thermostat to the temp you want and function knob to the setting you want set the cooking time as follows.
You press the button that looks like steam coming off a pan below the clock for 1/2 second .
Then use + an - keys to set the minutes. Every 12 minutes will make a new segment light up on the inside ring so the numbers corospond to hours on the inside ring.
When the time is where you want it, wait 6 to 10 seconds and the cooking and timer will start.

Smeg A42 5 Instruction Manual

Smeg A42-5 Dual... | Answered on Jun 05, 2014 | 147 views

1 Answer

Smeg oven SUK62CMX5 dial transfers have come off

I used ovenlettering.co.uk for replacement decals for my oven. Easy
to apply.

Smeg SUK62CMX5... | Answered on Mar 20, 2014 | 442 views

2 Answers

Smeg main oven failure

This tutorial will show you how to check your Smeg element and how to replace your Smeg cooker element.
Here are the 3 main faults to look for in your oven or cooker that is not heating

Your oven will not work until the clock/timer has been re-set after replacing an oven element or tripping the electrical supply. Consult your Smeg manual.
If your Oven is not getting hot or heating up it could be a faulty element, if the fan in the oven is running and the thermostat light is on, this will lead us to believe that the element has gone faulty. With grills the thermostat light should come on there should be heat, if not then this could be the grill element or the thermostat.
When you turn the oven on, the household electrical supply trips on the Rcd (this is the earth trip in the fuse board sometimes called the breaker tripping) your fan oven element has gone to earth and needs replacing.

If this helped you why not get me a beer?
Paul is from the Naturally he would appreciate beer How to Repair Home...

Smeg A2.5 Dual... | Answered on Mar 05, 2014 | 695 views

2 Answers

Cooker not heating up

removed broken element and replaced it. You have to access the fixing screws from the back of the cooker to remove it

Smeg A2.5 Dual... | Answered on Mar 05, 2014 | 872 views

2 Answers

Smeg oven and hob ubit:

This tutorial will show you how to check your Smeg element and how to replace your Smeg cooker element.
Here are the 3 main faults to look for in your oven or cooker that is not heating

Your oven will not work until the clock/timer has been re-set after replacing an oven element or tripping the electrical supply. Consult your Smeg manual.
If your Oven is not getting hot or heating up it could be a faulty element, if the fan in the oven is running and the thermostat light is on, this will lead us to believe that the element has gone faulty. With grills the thermostat light should come on there should be heat, if not then this could be the grill element or the thermostat.
When you turn the oven on, the household electrical supply trips on the Rcd (this is the earth trip in the fuse board sometimes called the breaker tripping) your fan oven element has gone to earth and needs replacing.

If this helped like us on Facebook please How to Video Tutorials on Domestic Appliances

Smeg Kitchen... | Answered on Mar 05, 2014 | 507 views

1 Answer