Siemens Dryers - Page 7 - Recent Questions, Troubleshooting & Support
Our siemens WD12D520GB [iq300 washer dryer] often
This info should be on the insert hidden somewhere in the machine..look behind the lower kick panel..under the lid...on back...somewhere for the folded paper insert.Theses are Error coder specific for this manufacturer.
Replace bearings
CASH WELL APPLIANCE PARTS......AND YES JUST GET THE WHOLE KITE..BUT IF IT STILL DOES IT THE NOISE IS COMEING FROM THE MOTOR..THERE FOR NEW MOTOR
My dryer won't start
need to know model and make ,but suspect thermal cut out on heater, if unit has been moved it need to settle before it will run 4 ot 6 hours.. i have seen good units been binned they just needed to rest.
Siemens Condensor Dryer E46-38. After a few
Mine is 4 years old and the pump went within 8 months! The dryer has had 6 new pumps in total! It was last fixed 6 months ago and now playing up again! I dont even constantly use my dryer! I am very disappointed with Siemens now, my last dryer lasted me 10 years and it was constantly on the go when my children were young! Here comes, tomorrow I have got to book another repair! No more Siemens for me.
Clothes are to hot to touch, already cleaned dryer
Check to make sure that your cycling thermostat is operating properly. Also make sure that drum is rotating. What it sounds like is that the machine has either an air flow problem or thermostat problem. Try running the machine with the vent off, only if it is electric, not gas dryer. Also check your blower to make sure it is tight on the motor shaft. That would impede air flow and cause overheating. Btw, I’m available to help over the phone in case u need at
https://www.6ya.com/expert/gary_58e9c3508cafe590
Dryer stops after a few minutes Siemens WTXL2101 EU/07
Maybe a sensor at the back sensed overheating. You might be able to remove the backplate and search for a little button, which acts as some sort of reset button. (I do have a different tumble dryer, but it's the same brand and had similar problems). Maybe more ventilation is needed to prevent this from happening again.
4/7/2013 6:41:31 PM •
Siemens...
•
Answered
on Apr 07, 2013
Not finding what you are looking for?