Servis Dishwashers - Recent Questions, Troubleshooting & Support

0helpful
1answer

Hi my Servis M4905 Dishwasher has stopped working properly, when you set the programme and close the door it seems to start its cycle but after a few minutes it stops all the lights come on except the

Hi it may be that the heating element has a fault in other words short circuit, you will need an electrician or a service engineer to check that, as the water fills into the washer it then tries to heat the water first to carry out further duties in the cycle. I hope that this message might help you eric
11/16/2017 8:55:17 AM • Servis... • Answered on Nov 16, 2017
0answers
0helpful
1answer

My servis tumble dryer m2002w wont turn theres power ,belt is fine and it heats up

Does it turn by hand? Bad bearings?
5/7/2014 5:47:34 PM • Servis M4904 • Answered on May 07, 2014
0answers

Servis m9409s

Be the first to answer 4/1/2014 3:52:25 AM • Servis... • Posted on Apr 01, 2014Be the first to answer
0helpful
1answer

My Servis integrated dishwasher will not heat up.

sounds like the water is not reaching the correct level.try waiting for it to fill and then put a jug of water in.if it heats up that's the prob -- not enough water if still not heating your NEW element may have failed - not uncommon if its a pattern part.
10/2/2013 5:01:57 PM • Servis... • Answered on Oct 02, 2013
0answers
0helpful
1answer

Dishwasher do not empty

Make sure drain hose is not crimped and is t a 90 degree angle
9/3/2012 3:48:29 AM • Servis... • Answered on Sep 03, 2012
0answers
0helpful
1answer

M4306 (I think) won't fill

Hi,Here is a tip that will help you to find out why water will not come into thedishwasher... Dishwasher Trouble No Water entering Dishwasher heatman101
9/25/2011 4:09:03 PM • Servis 23 in.... • Answered on Sep 25, 2011
0helpful
1answer

Dishwasher not draining have tried

It is a common fault that the drain fails to work in most machines in a period of time and is the most problematic fault in a dish-washing machine, due to food waste clogging the drain. In all occasions it is important that your observation is most important and so is vital to the identification /rectification and solution. If you have noticed that water has leaked then as the drain hose pump/valve and fittings are located on the underside of the machine it is important that you look for possible leaks here. In some cases the drain hose would be clogged at the drain end to outlet of the house and so there will be back flushing resulting in overflow to the outside. Also the drain pump/valve can be clogged. Now remove the drain hose clamps and remove the drain pump/valve, clean the drain pump/valve, use back flushing to clear off all dirt. Now test using power to see if this works and can be simulated. When refitting, the hose must be tightened properly. If the pump/valve does not work even with power then it must be replaced. If there is intermittent power to the drain valve/pump then the program controller unit is a suspect.

Finally the washer must be placed with a tilt- use a spirit level- so that all water will drain to the outlet port and thereby there is no residual water remaining.

8/8/2011 12:21:33 PM • Servis... • Answered on Aug 08, 2011
0helpful
1answer

My dishwasher has always washed

Hi,
Probably because it is hooked up wrong...

The water feeding it should be hot water... meaning it should be hooked into you hot water piping, not the cold water...

The dishwasher will keep hot water hot but it is not powerful enough to heat the cold water up...

heatman101
7/16/2011 5:26:11 PM • Servis 23 in.... • Answered on Jul 16, 2011
Not finding what you are looking for?
Servis Logo

39 questions posted

Ask a Question

Usually answered in minutes!

Top Servis Dishwashers Experts

Marvin
Marvin

Level 3 Expert

85241 Answers

mark warfield
mark warfield

Level 3 Expert

453 Answers

Brad Brown

Level 3 Expert

19166 Answers

Are you a Servis Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...