Sears Building Materials - Page 3 - Answered Questions & Fixed Issues
Door dosent close.move about 1 ft then opens
You may not have had the motor shaft pushed all the way back when you tightened the coupler after replacing the worm gear. Loosen the coupler up and from the front of the motor (opposite end in which the coupler is on) push the shaft back as far as it will go. Hold it there while you tighten the coupler back up and then try it.
My keypad does not have a enter button and im
I had the same problem and I found an old Liftmaster keypad instruction handbook. Check out the picture below and follow what it says. It worked for me!
P.S. Sorry if the picture is hard to see.
P.P.S. To change your 4-digit PIN:
Enter existing PIN, press *, enter new PIN and press *. To test and use, enter your new PIN and press the 0 key.
Need Replacement nutone garage door openers
unit must be ancient. try sears for a universal radio control set. if unit is as old as i think, i would toss it and get a new one. you will not be able to get any parts for this unit and it does not have safety beams.
The hand held divice stopped working and the
The most likely problem here is that your wall control is bad. I would disconnect the 2 wires going to it and I think you will find your remote works. Replace the wall control.
Garage door open and closes by itself
Anytime a door opens and/or closes randomly or doesn’t work consistently I look for a smashed wire between the motor unit and the wall button.
If the wire is smashed the insulation becomes so thin that power will leak thru the insulation and activate the door or interfere with the remote signal.
Loosen the staples with a small screwdriver and slide the wire about ½ inch to move any areas of thin insulation away from the staples.
The second thing would be a bad wall button or a remote with a sticking button.
Or a remote in someone’s purse that gets the button pushed by other stuff in the purse.
The test is to disconnect the push button wires at the power unit. If the self operation / interference stops you have located the problem. If you reconnect the wires and disconnect the wire at the wall button this will tell you if the problem is the wire or the button.
HOPE THIS HELPS
Changing PIN
ok... got it " LiftMaster Professional Model # 2575". Is this correct...?
Kindly wait & I will post back here again...
Regards,
micro
GEAR END AT DOOR DOES IT HAVE TO BE MOUNTED TO HEADER WALL?
It can be mounted to a ceiling rafter, but make sure there is room above to allow for the trolley to travel freely. If there is a clearance issue, there are top roller adapters called "quick turn brackets that make the top of the door turn faster and lower. Most likely available from your local garage door company.
Not finding what you are looking for?