Ruud Heating & Cooling - Recent Questions, Troubleshooting & Support

Ruud Electric Furnace Cannot Reach Setpoint - "Watt Restrictor"?

unfamiliar with watt restrictors.
heat strips have 2 safety devices, a thermal overload, they get to hot they shut off, cause not enough air flow increase fan speed this device is auto reset. a fusible link a fail safe to thermal over load, no reset and sometimes replaceable. if this does not help would like to ask you a few questions. one of the buildings i take care of has 200 + reem/ ruuds all electric heat. if a part is defective replace, please do not by pass. safety frist.

Ruud UBHC Air... | Answered on Feb 05, 2020

1 Answer

My RUUD pvp50fw 'Power Vent' unit lights, but the flame goes out in a second or two, blows a while, then power cycles.

Is the blower extinguishing the flame? If so, you have a leak in the cowling. Just a thought..

Ruud Heating &... | Answered on Dec 08, 2019

1 Answer

I need owner's Manuel for Ruud air conditioner model uamb048jaz

Possible free manual online, as Rheem apparently also produces Ruud models:

https://www.theacoutlet.com/documents/Installation-Guide-Rheem-RANL-RAPL.pdf

Ruud Heating &... | Answered on Nov 10, 2019

1 Answer

Ruud furnace owners manual?

online search using make and model

Ruud Heating &... | Answered on Oct 08, 2019

4 Answers

Is there a manual for preventive maintenance?

every 3 months and more in the summer I spray my outside unit with a garden hose. I start at the top of the grill and work my way down. dirt and grime will come out the bottom. jeff

Ruud UAKA048 Air... | Answered on Sep 22, 2019

4 Answers

Why is the outside air conditioner unit not turning on

Could be a bad capacitor.

Ruud Central... | Answered on Sep 08, 2019

1 Answer

The blower motor on my Ruud Silhouette II slow down when running for an instant them picks up & finishes the cycle.

Likely have a module going out.

Ruud Heating &... | Answered on Jul 07, 2019

1 Answer

WHERE IS THE AIR FILTER LOCATION ON RUUD MODEL UAND -042JAZ

Filter is located in air handler, the are very easy to change. Do not use the cheap filters/

Ruud Heating &... | Answered on Jun 09, 2019

2 Answers

What is the "ton" rating of a RUUD UPNJ-037JAZ

3 ton.

Ruud Heating &... | Answered on May 29, 2019

1 Answer

What is the ton rating of my RUUD UPNJ-037JAZ heat pump?

By googling your question

3 Ton

Ruud Heating &... | Answered on May 20, 2019

1 Answer

What tonnage is ruud UBEA-21J14SFEAI

That model number is for an air handler (indoor unit) and not associated with tonnage. Air handlers are more often rated according to CFM and auxiliary heat.

In order to get the tonnage you would need to look at the model number of the outdoor unit (likely a heat pump). Typically tonnage is expressed in 1000s of BTU/hr, i.e. 24 = 2.0, 30 = 2.5, 36 = 3.0, etc.

Ruud Heating &... | Answered on May 05, 2019

2 Answers

Heating unit blows warm air then turns to cold air

it sounds like unit could be kicking out the low pressure switch or if it is a electric furnace it could be the sequincers

Ruud UBHC Air... | Answered on Mar 13, 2019

2 Answers

Rudd Model # UGDJ-05EAUER , can t find the part number for the induction fan.

You dont need a part number you need voltage horsepower and rpms. shaft size too

Ruud Heating &... | Answered on Feb 26, 2019

2 Answers

I have a ruud furnace that pilot stays lit but furnace doesn't want to kick on until I go down and hit the right top hand side of it, any clue what it could be?

sounds like the relay in the control is not pulling in

Ruud Heating &... | Answered on Feb 14, 2019

2 Answers

I have a RUUD Model number UGDU-15EARJR and the blower fan is not coming when in a call for A/C

If you turn your T.Stat to run and it comes on but in the auto mode it does not come on and the condensed compressor and ODF COMES ON sounds like you need a circuit board

Ruud Heating &... | Answered on Jan 18, 2019

2 Answers

I have a Achiever 90 Plus RUUD Furnace. Model: UGRA-10EZAJS. what draft induction blower can I put on it

Did you get a answer yet?

Ruud Heating &... | Answered on Jan 18, 2019

2 Answers

Ruud furnace is flashing code 55. What does this mean?

look on inside of doors of unit for codes

Ruud Heating &... | Answered on Jan 18, 2019

1 Answer

How can I change fan speed on a RUUD RCHA-48A1GG21 unit?

need model number from blower casing not coil casing but typically fan speed can be adjusted from control board mounted on blower motor housing.

Ruud Heating &... | Answered on Jan 13, 2019

1 Answer

I have a Ruud ugph-07eauer furnace. When it starts up the draft fan will run for a few seconds then shut down, and the OK light will blink 4 times, which means the pressure switch is closed. Help.

Pull the hose out from pressure switch and check for any restriction ,also clean where hose is connected to from furnace because that will get clogged

Ruud Heating &... | Answered on Dec 19, 2018

0 Answers