Russell Hobbs Kitchen Appliances - Others - Page 3 - Recent Questions, Troubleshooting & Support
Russell hobbs kettle base won't turn on
Just pulled apart a Russell Hobbs Whisper Model 3090 cordless kettle which i have been using every day for a few years.
It was intermittent turning on.
I fixed that problem by bending one of the switch contacts on the inside just a little as it had burned away slightly and was only making contact sometimes.
When I put the bottom back on and tested it I noticed that the water had an electrical smell which was strange as I had never noticed it before.
I then pulled it apart again and noticed that one of the main wires from the switch to the element had the insulation melting so I replaced that wire and now there is no smell in the water.
To confirm the smell I held the old wire and insulation on a flame and that is definitely what the smell was. The smell was travelling UP the tube which takes steam down to the bimetallic strip to turn the kettle off and was contaminating the water in the kettle.
When filled with water & put on to boil it
I think you would only solve this problem by cleaning the thermostat contacts, or replacing the thermostat which wouldn't be worthwhile as it's likely to be cheaper to buy a new kettle.
Besides this , just getting into the kettle needs special 3 tongue screwdriver and then a certain technique to open it up without damaging the plastic parts. Im'e afraid its a throw-away world now and its not good .
Not finding what you are looking for?