Ridley Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 36 Products
  • 63 Answers
  • 7K Views

Hi, Anonymous I would love to help you with your motorcycle question but due to the magnitude of yesterday's solar flare the batteries in my crystal ball are dead and my telepathy headset circuitry was melted. I need the year, make, and model of your motorcycle please click on " Ask For More Information" directly below and provide this information in the box that will open and then click on the green "SEND" box in the bottom right-hand corner. Good luck and have a wonderful day.

Ridley... | Answered on Jul 14, 2020


Hi, Anonymous I would love to help you with your motorcycle question but due to the magnitude of yesterday's solar flare the batteries in my crystal ball are dead and my telepathy headset circuitry was melted. I need the year, make, and model of your motorcycle please click on " Ask For More Information" directly below and provide this information in the box that will open and then click on the green "SEND" box in the bottom right-hand corner. Good luck and have a wonderful day.

Ridley... | Answered on Jul 06, 2020


Hi, Drew for this scenario you will need your service manual that has all fastener torque specs -fluid capacities and a wiring diagram on the back pages, parts fiche, and owners manual if you can not find the best tool you ever bought for your Ridley, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.google.com/search?sxsrf=ALeKk010p4bLxC5QXjl3dBQjcjHacqzm3g:1593668989470&source=univ&tbm=isch&q=ridley+auto+glide+tt+wiring+diagram&sa=X&ved=2ahUKEwiHy4bQ763qAhWGMd8KHYPGBBMQsAR6BAgKEAE&biw=1440&bih=757
http://ridleymotorcycle.com/instructions/Part%20Diagrams.pdf
https://gist.github.com/anonymous/fc88447e26d38c740b4bdb0c4f9fb11c
https://www.genuinemotorcycleparts.com/parts/Ridley/Auto-Glide-TT/
https://www.manualslib.com/manual/1016895/Ridley-Motorcycles-2006.html

Ridley Auto... | Answered on Jul 02, 2020


In my limited experience the handlebar wiring usually can't be unplugged but has to be disconnected from the handlebar controls and unthreaded from the handlebar.

Ridley... | Answered on Jun 27, 2020


Hi, Charles and the usual suspects are:
1. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
2. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
3. Faulty main circuit breaker and or connections.
4. Faulty ignition coil and or connections.
5. Faulty spark plug, oil or gas fouled, wrong heat range or service type, wrong gap, loose in the cylinder head, broken electrode or insulator.
6. Faulty spark plug cables, leaking or broken, internal damage check for spark leakage in the dark.
7. Faulty ignition module, switch, CKP, MAP, CMP, sensor and or any connector in the ignition circuit could have corroded, loose, or broken pins/sockets
8. Burnt exhaust valve or air leak in the exhaust system.
9. Improper valve clearance (too tight).
10. Check for generated diagnostic codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.motorcycleforum.com/threads/exhaust-backfire-popping-when-letting-off-throttle.92020/
https://www.youtube.com/watch?v=1wXGtRceW_g
http://www.ridleymotorcycleparts.com/categories/OEM-Parts/Shop-Manuals-%26-Documents/
http://www.ridleymotorcycleparts.com/
http://www.ridleymotorcycleparts.com/pages/Instructions.html

2007 Ridley Auto... | Answered on Jun 15, 2020


Hi, Ana what is your question? Thanks Gregg

Ridley... | Answered on Mar 19, 2020


Hi, Anonymous for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Ridley, despair not, for a mere $99 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.youtube.com/watch?v=BVXnbrigYf8
Checking your harley Stator charging system Insulation breakdown
http://www.ridleymotorcycleparts.com/products/Service-Manual-%28Auto%252dGlide-%2703-%252d-%2709%29.html $99
http://www.ridleymotorcycleparts.com/categories/OEM-Parts
https://www.manualslib.com/manual/1016895/Ridley-Motorcycles-2006.html

2008 Ridley Auto... | Answered on May 10, 2019


Hi, Peter and the usual suspects are:
1. Fuel tank empty.
2. The fuel tank has old dead gas.
3. Fuel tank bottom contaminated with ethanol sludge, dirt, water, rust, etc.
4. Fuel supply valve/petcock turned off.
5. Fouled spark plugs.
6. Engine flooded as a result of overuse of the choke.
7. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
8. Fuel valve/petcock or filter clogged.
9. Fuel line to carburetor or throttle body pinched, kinked or blocked.
10. Carburetor float stuck.
11. Fuel injectors clogged.
12. Fuel injectors stuck open.
13. Quick disconnect check ball stuck.
14. Compression below 75 PSI.
15. A stuck-bent-burnt valve.
16. Improper valve clearance (too tight)
17. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a cursory reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
18. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
19. Loose or corroded wire connection at the coil or plug between ignition sensor and ECM module.
20. Spark plug cables in bad condition and shorting check for spark leakage in the dark, cable connections are loose or connected to the wrong cylinders.
21. Ignition timing incorrect due to a faulty ignition coil, ignition module or MAP, CMP, CKP, O2, TPS, ETP, IAC sensors.
22. Faulty neutral, clutch, kickstand safety switch.
23. Faulty fuel pump or fuse or relay.
24. Faulty or corroded run/stop switch.
25. Tilt sensor needs a reset.
26. Security system not disarming alarm needs a reset.
27. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
What To Do If Your Motorcycle Doesn Start
3 Things to Look for When Your Motorcycle Won Start The Allstate Blog
Ridley Motorcycle Manuals Documents for Ridley Auto Glide and Speedster...
http://www.ridleymotorcycleparts.com/categories/OEM-Parts
https://www.manualslib.com/manual/1016895/Ridley-Motorcycles-2006.html

2007 Ridley Auto... | Answered on May 09, 2019


Hi, Wendy and the usual suspects are:
1. Idle port, transfer ports, slow air jet clogged.
2. Idle adjusting screw set too low.
3. Air fuel mixture adjustment too lean.
4. Pilot/slow fuel jet clogged.
5. Faulty accelerator pump.
6. Float level too low.
7. Float bowl contaminated old fuel, water, dirt, rust, etc.
8. Carburetor bowl vent line clogged/blocked/pinched.
9. Fuel line to carburetor kinked or pinched.
10. Fuel filter clogged.
11. Intake manifold leak.
12. The gas cap is not venting properly or fuel tank venting system blocked.
13. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
14. Needle and seat stuck closed in the float bowl.
15. Multi carburetors not in sync.
16. Faulty fuel pump or internal fuel line has pinholes.
17. Fuel injectors clogged or faulty.
18. Faulty throttle position sensor.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
engine dies with quick throttle blip
Engine cutting out when opening throttle from idle
Ridley Motorcycle Manuals Documents for Ridley Auto Glide and Speedster... servicer manual $99
http://ridleymotorcycle.com/instructions/Part%20Diagrams.pdf
Ridley reg Genuine Parts
http://www.ridleymotorcycle.com/manuals/ownersmanual_classic_2006-pdf.pdf

2007 Ridley Auto... | Answered on Oct 27, 2018


Hi, Steven for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can't find the best tool you ever bought for your Ridley, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
2006 Ridley Auto Glide Sport wiring diagram Google Search
http://ridleymotorcycle.com/instructions/Part%20Diagrams.pdf
Ridley Motorcycle Manuals Documents for Ridley Auto Glide and Speedster... service manual $99
Ridley reg Genuine Parts
Ridley Motorcycle Manuals Documents for Ridley Auto Glide and Speedster... owners manual $25

2007 Ridley Auto... | Answered on Aug 29, 2018


Hi, Andy tire pressures are stamped on the tire sidewall. Good luck and have a nice day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Ridley... | Answered on Oct 25, 2015


Hi Budz, for more information about your question please visit the website below. Good luck and have a nice day.
Ridley Motorcycle Instructions

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2008 Ridley Auto... | Answered on Sep 10, 2015


Hi Budz, for more information about your question please visit the website below. Good luck and have a nice day.
http://ridleymotorcycle.com/instructions/2008-wiring.pdf

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2008 Ridley Auto... | Answered on Sep 10, 2015


Gak paham baha inggris ni

Ridley... | Answered on Apr 16, 2015


There are 2 fuses under the seat thats about it google the owners manual its available :)

2008 Ridley Auto... | Answered on May 02, 2014

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Ridley Experts

Mike

Level 3 Expert

4369 Answers

Vernon Taylor

Level 3 Expert

6684 Answers

ray gallant

Level 3 Expert

68629 Answers

Are you a Ridley Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...