Ridgid Recent Questions, Troubleshooting Help & Support

https://www.ridgid.com/us/en/product-registration or the equivalent in your country

piston kit

make sure its lubed real good and use a board at top of cyl and hit it in with hammer it will go in

tighten all the way the side that flaps should be flush to head

More details for diesel generator set, contact [email protected] or visit www.dieselgeneratortech.com

It's the soft start feature of the saw that keeps your breakers from tripping or lights from dimming when the saw starts. Saw works perfectly fine without it.

best guess is the switch, the reversing links might be burned, typical for a reversing switch were the operator does not wait for the motor to stop before switching in reverse

https://www.ereplacementparts.com/ridgid-wd06350-gallon-wetdry-vac-parts-c-7929_15282_15287.html

If the part is missing you are stuck on that one, no fix that I have seen here, in fact I have never seen a single question about this make of table saw.

Hello Dan Cappel, Normally I point these questions to: ManualsLib Makes it easy to find manuals online but before I will usually see if an AUGUST Mfr. like RIDGID Provides decent CUSTOMER contacts (RIDGID does): Customer service: +1 888-743-4333Founded: 1923 Headquarters: Elyria, OHParent organization: Emerson Electric Carnac the Magnificent

It seems like the compressor head is not pumping air. No air pressure at all on gages at all? No air leaks? disconnect the compressor head (t- joint) and varify air is or is not being pumped. Compressor air inlet filter section, you can also varify that air is being sucked in to the compressor head there by the pump action.

Check your wiring, Line to line, load to load. Line is power coming in, load is to the motor. Check for packing that should have been removed. Inspect the pressure switch contacts to make sure they open at desired psi and adjust as necessary. A nut or screw pushing on a spring adjusts tank psi. Loose unloaded spring is less pressure, tight compressed spring is more pressure before cut off..

If it's gunked up with tar, I would spray WD40 to clean it up. Silicon spray is a good lubricant for maintenance of certain tools

I would first make sure there is power going to it, switch it on, tap on the pressure/power/control switch, open it up and visual inspection of the contacts to varify the contacts are closed or on. Look for a reset button, the electric motor may have on on its end bell. Use a voltage tester as needed, caution, electricity may cause injury and even *****.

What cutting compound are you using?

Your options appear to be: 1) contact the manufacturer: 800-474-3443 https://www.ridgid.com/us/en/contact-us 2) try to find the part on ebay Here it is on ebay (purportedly): https://www.ebay.com/i/One-1-Ridgid-trunnion-clamp-shoe-part-823565-for-14-bandsaw-/112577506256?rmvSB=true 3) check the users forum on the www.ridgid.com website 4) look for a used one for parts I have no way of knowing the part numbers and how such might match with parts sold on ebay. The manufacturer might be able to help with such. The part number you supply appears to be for a "shoe." I do not find replacement sources.

did you swap batery fi\or a fully charged one? next would be replace switch part #18 https://www.ereplacementparts.com/ridgid-r84001-after-g0344-18v-speed-cordless-drill-driver-parts-c-7929_8250_8855.html

Mine also, in the middle of a job and it just stopped, no warning , did not slow down or bog just quit.