Remington Garden - Recent Questions, Troubleshooting & Support

You might try the following

Remington Garden | Answered on Oct 14, 2020

Remington Pole Saw Carbon Brushes
If you're Remington Pole Saw is slowing down, throwing sparks, or not starting you may need to replace the carbon brushes. Replacing brushes and cleaning commutator early can prevent damage to motor armature!
Remington carbon brushes on E-bay Search for:
Remington Pole Saw 8 AMP Carbon Brush

Remington... | Answered on Feb 08, 2020

check for a roll pin in the gear or shaft that has sheared off
check that the square end of the drive shaft is not rounded off or that the square drive in the gear is in fact locking on the drive shaft and not turning from worn out

Remington... | Answered on Dec 28, 2019

Have someone tried bulk ammo deals with free shipping at Ammo Board?

Remington Garden | Answered on Nov 04, 2019

Here is a helpful video that will show you how.

Remington Garden | Answered on Sep 21, 2019

To change that trigger switch on a Remington saw, you need to open up the two handle halves and expose the switch. The wires are just "poked" into the switch, so you can make a tool to release them. I used a 1/16" diameter short length of wire and flattened about a 1/2" of it on an anvil. Push it in next to the wire and the wire will pull out, wiggle the tool a bit and it will pull out too. Push the wires into the new switch and put it all back together.

The switch is probably a #077525S ...seen them out there for $8 to $15.

Remington... | Answered on Sep 13, 2019

No threads, it snaps in and can be snapped out if you are careful.

Remington... | Answered on Sep 13, 2019

Okay here is the Fix for the Remington Pole for the remington saw. Lowes has a plumbing part that will work as I just purchased it 12/2010 The part is by GENOA and its a 3/4" pvc Union and the threads match. Its Lowes part 98996 and its < $6.00

Remington... | Answered on Jul 23, 2019

1. Try a penetrating oil, like product "deep creep". WD-40 is not a penetrating oil, it is a water displacement oil. Proper penetrating oil should work. 2. Try soaking in house hold, distilled vinegar, the really cheap stuff. For a few hours, and try again.

Remington Garden | Answered on Jul 14, 2019

check oil lines and when storing saw stand on end or on side blade up.. vote if'n i was of help.. remember BUY USA MADE PRODUCTS.. Jay

Remington 16"... | Answered on Apr 10, 2019

well if its an electric powered model as the title says it is , then the only oil it should have is Bar/chain oil there should be a little cap just forward to left of the trigger this should be kept full of bar/chain oil for its use

Remington... | Answered on Apr 10, 2019

Not finding what you are looking for?
Remington Logo

1,118 questions posted

Ask a Question

Usually answered in minutes!

Top Remington Garden Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Dale Long

Level 2 Expert

192 Answers

Sheldon Dedek

Level 3 Expert

912 Answers

Are you a Remington Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides