They may be correct I could not say but if the item is more than say three years old (Good Branded items may go to five) then cost would become too much if spares exist.
Flat screens on TV's make up about 2/3 its cost to make while the mainboard mostly was made using very high technical methods which do not permit easy repair. Exchange panels are the norm with some very limited repairs on some parts, most insurance on such items rely on replacement products but then charge a fee for the pleasure of it.
I had a TV that had insurance which was 9 years old I was offered a replacements for £100 - £150 with £30 - £50 delivery charge when it failed.
If you are want to try repair then I would talk direct to the company Toshiba to see what they say if possible use one of their agents (though I suspect you have) sadly it may be time to change as repairs become yesterdays methods, I see many many money/swap shops filled with tablets etc I figure most have defective batteries that are unable to hold a full charge anymore.
Hope this helps.......
Sounds like The main power supply regulator section circuit fault. Either it will be a separate board, or the part of main board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/
It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and time. Even though you can make it right, it will cost around an amount equal to the cost of a new board; including the cost of (spare parts + service charge) More to say, most of the spare parts to it will be difficult to get from open electronic spare part market. This is true to most of the flat panel TV power supply boards; irrespective of its brand and screen size.
Search the site by type in the "brand name" to your device; in the "Search box at the top right of the display window of the Homepage" to get gathered related posts.
Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Pull up older posts. http://electro-medical.blogspot.com/ In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.
Before going further; try a hard reset first. If it does not help you, replace the main digital board. There are two methods to reset TVs. The first is simple to do; a Hard Reset. The other is somewhat skilled; is a Factory Reset (System Reset). To make it a hard reset, just unplug the TV from AC mains wall socket, and re-plug it back after 15 minutes or so. If you do this by overnight is better. This procedure will make it a hard reset. If you want to make it a system reset [Factory Reset]; you have to enter its service mode option, and select the factory reset option. If you wish to get some details; visit the site linked here.
Back - light problem. Check and replace damaged component/s at its back-light inverter board, or replace this board as card basis. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. It will be best to replace the inverter board as card basis. http://electronicshelponline.blogspot.com/ To some model sets; especially LED back-lighted types; the back-light inverter circuit will be part of the main power supply board [SMPS]. In such cases, the power supply board might need replacement. To some models sets, the back-light inverter and SMPS section circuit will be integrated at its main board itself. If so; the main board should be replaced. To some models of sets, all these section circuit will be integrated at its main board. If this is the case, you have to replace the main board...
2402,2469,2414. Check these codes. If you wish to get more details; check the sites linked here. It has set-up code list & set-up procedure to many popular brand remote controls. Common set-up codes to check with TVs and other devices are given, in the order of the "device's brand name" in alphabetical order. Pull up older posts. Surf the site with patience. Surf the sites by type in the brand name to your set, in its search box.
http://electronicshelponline.blogspot.com/http://remotesearch.blogspot.com/http://electro-medical.blogspot.com/http://electrohelponline.blogspot.com/
Type in the brand name of your device, in the search box [at the top right] of the display window and the Search will start at once as you type in, and will show you all the related posts. It will make surf easy.
Main system control memory IC fault. Contact any service technician to replace it. If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/
Question edited for clarity and add CAPS.
Question moved from Misc to Televisions.
Do a power Reset on the television. Disconnect the television from the mains plug overnight. In the morning, press and hold the power button for 43 seconds. Let go and plug the set in.
Turn the set on. Use the remote to press the Source button to move the source to the HDMI port the OHVD box uses.
Maxdorf is a brand that we don't have here in North America.
https://www.google.com/search?q=Maxdorf+TV
..
If your Wisdom Share Smart Cloud TV is stuck on the startup screen, you can try the following steps to troubleshoot the issue: Power Cycle the TV: Disconnect the power cord from the TV and wait for about 1-2 minutes. Then, plug it back in and try turning on the TV again.Feb 25, 2024
JustAnswer
https://www.justanswer.com > TV Problems
May 25, 2023 - The first thing to try is a Hard Reboot as this is the least invasive thing you can do. Unplug the TV from power for five minutes.
1 answer · Top answer: Hello, my name is ***** ***** welcome to JustAnswer.com, the industry leader for
..
JustAnswer
https://www.justanswer.com > Electronics Questions
Feb 12, 2024 - If the power light is flashing, it usually means the TV's self-diagnostic system has detected a problem. Here are some things you can try: ...
1 answer · Top answer: Hello, my name is***** and I'm a TV expert here at JustAnswer. Rest assured, we will work ...
