Reddy Heating & Cooling - Page 9 - Recent Questions, Troubleshooting & Support
How to bypass photocell
not a chance lol customer tried and blew the board plus ready heater is out of bis bt parts a readily avalible
12/13/2013 3:29:17 AM •
Reddy...
•
Answered
on Dec 13, 2013
Starts runs for 3minutes then shuts off
pressure should b at 6 to 6.5 clean nozzle check for cracks in air ling and fuel make sure both filters r clean and the flame sensor is clean good luck
12/13/2013 2:54:57 AM •
Reddy...
•
Answered
on Dec 13, 2013
Need a new roter complete
r your fingers in the pump the wrong way there not square and have to b in right or they don't spin don't force good luck
Have an rlp30 reddy heater, have spark and gas but will not light.
wile red button is pushed no flame or turns off when the button is released the flame dies ? if no flame tank is too small or spark isn't in far enough to catch gas . if flame is present with button down then the over heat switch on the in line thermal coupler could b bad u can check the over heat switch with a jumper between the two wires and if it stays lit you got it if it goes out then its the thermal coupler that's bad
Need to replace fuel tank has a hole in it
go to auto parts store they have apoxy patch just for patching fuel tanks.. its a special patch material.. not to exspecive.. i have used it many times..
11/27/2013 7:01:17 AM •
Reddy...
•
Answered
on Nov 27, 2013
Wont start
Change the CAD flame sensor, it's a $3 part and they are all the same, just the mounting is different. Put it on your mount and sould be fine.
Not finding what you are looking for?