Razor USA Recent Questions, Troubleshooting Help & Support

I have the same issue with mine. Batterys check out fine.. i'm starting to suspect the motor??

Question edited for clarity. Question moved from Cars and Trucks. Get out your multimeter and check the TOTAL voltage. You should have 24 volts or 36 volts depending on model. If you don't, take them all of and charge each one on a car charger set at 2 amps. Clean all the battery connectors with a wire brush and also the connectors. Smear them with Vaseline. Also make sure you have the batteries wired in correctly. If don incorrectly, you may be running on 12 volts! https://www.google.com/search?q=razor+quad+low+power Batteries x 2 or x 3 https://www.google.com/search?q=razor+quad+batteries ..

If the battery is gone(bad), sometimes it will show fully charged (volts are good).. but it has no amperage to "push" the voltage... It takes amperage to make the drifter move... (time for a new battery)... they don't last long...

I need help! My son mx650 is charged, but won’t run. Put weight on it won’t move but lift rear tire off ground and runs full throttle

Electricity and water don't mix....do not ride _a Electric motor n the rain ,snow , light rain or any water...plz keep the motor dry or keep h20 from entering the motor vents....those 3 holes on each side..ok..that should do it....

power wire and ground make starter work inside starter case. the power wire goes through several safety switches on way to starter. check each connector 4 loose wiring. battery (-)to engine and frame need more history here b4 i can help anyymore. good luck

Do you own a multimeter to check the voltage output from the battery

batteries and bulbs