Razor Logo

Razor Popular Questions, Answers, Tips & Manuals

Do you work here? Claim your company

  • 103 Products
  • 876 Answers
  • 176K Views

so what had been hapening is that it could die depending if it was the battery that could aftfect with this. 24 volt battery, and can be ridden for up to 45 minutes after battery charging. The charge time recommended for this Razor electric scooter is about 10-12 hours after each use.

Razor Toys | 57 views | 0 helpful votes


Hi there, charging normally takes approx. 16 hours. Do not leave the appliance connected to the mains for more than 24 hours.

I have included a link for the user manual for this product.

Razor Toys | 59 views | 0 helpful votes


Here are the Super-Effective Ways to Get Rid of Razor Bumps.
A clean, glowing skin, devoid of any hair is what everyone wants. But things aren't that easy. The tiny red bumps always come in the way and ruin the look. These red bumps caused after shaving are known as razor bumps. If you frequently get these embarrassing bumps, then instead of stressing out, know how to get rid of razor bumps quickly at home. For more info: https://howtocure.com/how-to-get-rid-of-razor-bumps/

Razor Health &... | 87 views | 0 helpful votes


Generally, these razor batteries are not replaceable. They require soldering and skills that average people do not have. See this video.

Razor Health &... | 87 views | 0 helpful votes


Thoughts -
No/poor connection between power source and motor
Motor failure
Only someone with their hands on the bike can fully diagnose.

Razor Cycling | 164 views | 0 helpful votes


Hi,
You'll need to remove the keyswitch itself & either take it to a locksmith to have a replacement cut from the barrel
or
replace the entire keyswitch with a compatible replacement unit.!

Razor Cycling | 146 views | 0 helpful votes


it is a old charger ?

Razor Cycling | 365 views | 0 helpful votes


I think you are talking about an electric motor on your bike . If the motor is New you may have a bad throttle switch . You can use an ohm meter to check the throttle switch . Connect the two leads of the ohm meter to the wires of the throttle switch ( dissconected) . As you turn the throttle the ohm reading should coraspond to how much you turn it .

Razor MX500 Dirt... | 1,029 views | 0 helpful votes


BEST SOLUTION GO TO A GOODWILL MOST OF THE TIME THEY HAVE-
BIKES FROM $10.00 TO $40.00 AND YOU LOOK FOR A BIKE
THAT HAS A GOOD BACK WHEEL AND YOU'LL HAVE EXTRA
PARTS HERE IS A LIST OF PLACES GOODWILL&THRIFT STORE&
SWOPMEET THAT HOW I FIX MY BIKES..
HAPPY HUNTING.
D,R,CLAUDIO

Razor MX500 Dirt... | 404 views | 0 helpful votes


The Razor 13013290 Air Scooter's frame is made from aluminum steel which is strengthening strongly. This is why you can use the scooter for a long time.Click here for more details complete Razor 13013290 Air Scooter review

Razor Toys | 44 views | 0 helpful votes


Either the cheap lead acid batteries are near dead (mostly due to improper maintainance (lead batteries are way too much trouble and lithium should be considered!)
There could be a loose or corroded connection - check on all your wiring, especially the ones to the motor.
Also where it goes into the motor is fragile and people bump that area and it rips the wire, there is a steel spring that surroiunds the wire/s and this sometimes shorts out because of the damaged cause from laying the bike on it's side. check these wires over and tug on the connector wires to find the weak connection. Also verify that your charger turns red indicating it is charging when attempting to charge the bike, if it stays green chances are a dead battery or BMS controller inside battery (Lithium only!)\
Most repairs are very simple if you take the time to check out the connectors and wiring, especially if you use it in bad weather, things get corroded from being wet and power shorts out then corrodes the wires and connectors.
Good to insulate them for the rain etc...
Think Im on the right track here, and i have many ebike because people dont know how to fix simple issues with a tester.

Razor MX500 Dirt... | 1,760 views | 0 helpful votes


You don't say what brand e300, buy the connections are corroded. Doesn't matter how good it was taken care of previously. Being left out in the rain is all it took. This is why electronic devices TELL YOU to not expose them to moisture...
No telling which circuit board is fried, but if you solder, you can replace them one by one to find out.
But TBBH, for the time, aggravation, and cost, just go buy a new one if the original cost anything under $100.
If you paid more than $100 for it, call your local RC shop and ask who does repairs.
Could be your rotors (most likely - copper rusts by breathing on it), or a board connection. Rotors are not hard to replace if you can solder.
JMO, but if it is of value, always supervise kids when you let them "PLAY" with it...But hopefully, lesson learned all around. Best of success to you.

Razor E300... | 85 views | 0 helpful votes


Hello
Before you change the battery check thoroughly all wires and all connections!!!!

Razor Toys | 152 views | 0 helpful votes

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Razor Experts

Tom Chichester

Level 3 Expert

55379 Answers

Bill Boyd

Level 3 Expert

53800 Answers

Gregg Mahin
Gregg Mahin

Level 3 Expert

61842 Answers

Are you a Razor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...