Pro Office Equipment & Supplies - Popular Questions, Answers, Tips & Manuals
I have an optima pro 1505 projector. No remote. It keeps asking for unlock code .how do I bypass or reset. again. W,O. REMOTE
To bypass or reset the unlock code on your Optima Pro 1505 projector without a remote, you may try the following steps:
- Turn on the projector and wait for the "Enter Password" prompt to appear.
- Press the "Menu" button on the projector itself.
- Navigate to the "Setup" or "Options" menu using the arrow buttons on the projector.
- Look for an option called "Security" or "Password" and select it.
- Depending on your projector model, you may need to enter a default password such as "1234" or "0000" to access the security settings.
- Once you are in the security settings, look for an option to disable or reset the password.
- Follow the on-screen instructions to disable or reset the password.
If none of these steps work, you may need to contact Optima customer support for further assistance.
4/15/2023 3:50:37 PM •
Pro Office...
•
85 views • 0 helpful votes
How do I fix a bad Broadband for TV Pro Crystal HD antenna
1.Plugged up the power adapter from the wall. And to the antenna itself HD or tennis. Now for that I just went to the settings. I saw at first I couldn't find the settings on how to scan the channels.
2.Make sure the antenna is not blocked by the TV or hidden inside a cabinet. Always scan for channels on your TV or cable box after adding or removing an amplifier or moving your antenna.
3.Turn on your TV. Using your remote select the input and make sure it's on the DTV / TV or TV setting how this menu and your settings look will vary depending on the make and model of your TV.
4/25/2022 2:47:03 AM •
Pro Office...
•
37 views • 0 helpful votes
Memory is low - job cancelled on LaserJet Pro 400 message
you have jobs stored in internal memory you need to remove these before you start new job. the firm ware software will have the the wipe settings in the settings folder in software, aldo check in device properties for device that it has full use of the memory of the device some are set to 20mb put it on its highest memory setting.
6/22/2017 7:23:51 PM •
Pro Office...
•
4,077 views • 0 helpful votes
My Xacto School Pro pencil sharpener is only sharpening about one pencil at a time before "losing steam."
Most electric pencil sharpeners have a switch that shuts the sharpener off when it gets too hot. There may be multiple issues here.
First, the sharpener is overheating with one pencil. This shouldn't happen and may indicate an internal issue: either the motor is working too hard, or there is material inside the motor compartment insulating it an causing more heat build-up.
Second, the cut-off switch may not be fully disengaging the current. This could be a dangerous situation, as electricity is crossing where it shouldn't.
You may need to disassemble the body of the sharpener and clean debris out of the motor area. While in there, look for any bits of lead that could bridge a gap in wiring. Pencil lead is conductive.
2/7/2017 12:57:34 PM •
Pro Office...
•
858 views • 0 helpful votes
Not finding what you are looking for?