Omega Blenders - Page 6 - Recent Questions, Troubleshooting & Support
Bogs down under load
Is it a new blender or one that has worked before? Sounds like something is restricting the blades or not quite assembling correctly. What kind of blender? Any chance you could post a picture so we can have a look at how it assembles?
7/10/2018 1:45:53 PM •
on Jul 10, 2018
Fuse has blown and i replaced it under the top
Did you check to see if the original fuse was a slow blow version.
If you replace it with a normal or fast blow the start current could pop it
Other problem could be a developing problem on the heaters which as causing the current draw to rise
For that your need a megger to check for resistance through the machine or a PAT test should show it up
7/6/2018 9:24:04 PM •
on Jul 06, 2018
Are all blender rubber rings the same size?
Hello, Georgia -
No, there can be variations in size with the rubber sealing o-rings / gaskets for blenders.
I have no idea where you reside (in what country), so I cannot refer you to a bricks & mortar store or an online vendor to find the right replacement gasket.
Fixya.com receives questions from people world wide. I am answering from the USA.
Instead, I suggest you use your favorite search engine (Google, Yahoo, Bing, DuckDuckGo, etc.) and the following search strategy:
blender gasket replacement
The search results will list businesses selling a variety of replacement gaskets for specific brands.
5/29/2018 3:23:23 PM •
on May 29, 2018
Not finding what you are looking for?