Ocean Boating - Recent Questions, Troubleshooting & Support

There have a lot of ocean kayak in a market. It's very hard to select the best one. A beginner can not find the best kayak because they have not much knowledge about the kayak. A lot of brands of a kayak. The best one is select by the budget, I think the Vibe Kayaks Skipjack 90 is best. For more details about Ocean kayak, you may check here
Best Rated Kayaks in 2018 Tested Reviewed by Expert Anglers

Ocean Boating | Answered on Mar 24, 2018

Fishing in the deep sea is very much adventure. Fishing and kayak two are the most popular thing for enjoyment and it's also favorite hobby most of the people all over the world and the notable think that day by day its increase its popularity. when someone wants to go for fishing in the ocean, he must have to select the best fishing kayak which one suitable for him with more update features. The most important is that he has to select the sea kayak because there have a lot of types kayak in a market.In the market, here have many brands for a kayak. Each brand has their best kayak for ocean kayak. It depends on the budget, design, features. I thank the Vibe Kayaks Skipjack 90 is the best for it. For more details about ocean fishing, you may check here

Best Inflatable Kayaks in 2018 List of The Top Selling Models

Ocean Boating | Answered on Mar 24, 2018

Disconnect blk wire with yellow strip, from the power pack. Try restating motor and see if that cleared it up. If so, you have disconnected the kill wire at power pack.Let me know what that does for you.

Boating | Answered on Oct 08, 2017

Check if your oil feed hose isn't bent or cracked.
It' a sign the oil from your tank couldn't get to the engine fast enough...
If it's a 2 hose oil tank, check if your oil tank cap is wel sealed.

Ocean Boating | Answered on Oct 01, 2017

If this happens at both the command points ( remote control AND lower engine cover buttons) then check your relays.
You'll find both relays at the engine, 2 black cubes about 2cm wide.
The relay with green wiring is for down movement. The blue wiring is UP.
Switch both relays. If the engine goes down but not up. replace the relay. Otherwise check the wiring. One will be loose or broken.

Ocean Boating | Answered on Oct 01, 2017

If the sudden changes occures while the boat is plning, the changes are due to the passing of disturbet, turbulent, air bubbled water under the boat.
If they happen while the boat is still, probabily you detect some fish or other sea-life...

Ocean Boating | Answered on Sep 30, 2017

low water flow/pressure, low oil level
crank position sensor or blocked main jets in the carby , low fuel supply

Ocean Boating | Answered on Jul 02, 2017

Armor all or paint restorers found at auto supply stores.

Ocean Kayak... | Answered on Jun 22, 2016

Online, eBay, craigslist.

Ocean Kayak Two... | Answered on Jun 22, 2016

No poly-plastics of the type used in manufacturing can only be armor-all surface cleansed but makes the craft very slippery to lift and use. Color is restored though. Make sure there are no brittle areas that have been 'cooked' by the sun while stored in a yard. IMPORTANT!

Ocean Boating | Answered on Jun 22, 2016

fill the kayak using a hose and the drain-hole. every ocean kayak has a drain-plug. with water going into the shell, any holes will show up. Drain water and use.

Ocean Boating | Answered on Jun 22, 2016

Check the entire craft for brittle areas. It means that SUN-BAKING
has occurred. If the dent can be accessed from a port on the deck it is not a problem, but if it cannot, it may prove to be a weak spot. No WEAK SPOTS are allowed in a sit-on-top kayak. Get the longest craft you can transport/afford/lift always!

Ocean Kayak... | Answered on Jun 22, 2016

Oilcanning is a fairly common problem usually caused by improper storage or transport of your kayak, especially if it's hot out. Gently heating your hull (either by laying your kayak upside down in the sun on a warm/hot day or by using a heat gun CAREFULLY) MIGHT pop the dent out. If you were dealing with a single-hulled kayak, a little gentle pressure on the area with the dent while it's warm/hot would definitely do the trick. Not sure how I would approach a double hulled kayak, but it would probably be a combination of heat and pressurizing the inside of the hull or heat and water on the inside of the hull...would have to experiment.

Ocean Kayak... | Answered on May 17, 2015

paint and clear coat

Ocean Boating | Answered on Sep 18, 2012

Local hardware stores have fiberglass repair kits. Depending on how big the hole is (larger than a quarter), you might want to overlay it prior to patching. The hardware store should have a strong enough and thin enough material depending on the size.

The kits work well, just remember to let it cure for longer than required for a secure bond. My father snapped his entire canoe in half and was able to repair it and resume his trip out of the wilderness.

Ocean Frenzy... | Answered on Jul 29, 2012

Not finding what you are looking for?
Ocean Logo

23 questions posted

Ask a Question

Usually answered in minutes!

Top Ocean Boating Experts

ray gallant

Level 3 Expert

70831 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

34960 Answers

Bill Boyd

Level 3 Expert

53816 Answers

Are you an Ocean Boating Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides