NEC Office Equipment & Supplies - Recent Questions, Troubleshooting & Support
NEC VT595 Projector - Status light blinks red constantly
We had this same problem. In our case it turned out that a little bit of plastic broke off of a tab on the inside of the plastic lamp cover. Without that piece it was not pressing against the sensor that tells the projector that the lamp cover is closed. Without that, it doesn't start. We got it working again by drilling a little hole and sticking a screw through that spot to replace the missing plastic, but I'd rather replace the cover if I could. Really dumb that a little piece of plastic can mess up thousands of dollars worth of equipment (Smartboard 2000i).
NEC VT595 LCD...
on Jun 22, 2019
NEC LT240 has Power, Status & Lamp indicators lit & wont turn on!
If your bulb finally reaches it's end before you have the chance to replace it you unit will shut itself down and go into a permanent standby mode. Changing the bulb alone will not remedy the issue. The solution is quite simple but not posted in the manual or anywhere else that I could find for that matter! All that is required is to hold down the HELP button on your remote for 10 seconds while aiming at the infrared sensor on the unit. This will reset the units bulb timer and remove it from the standby mode.
NEC LT 240K...
on Nov 10, 2018
Clean optocoupler under pcb 4554B on color disc wheel.
Dusty on this part make not good sincronice with dlp panel.Good luck.
NEC LT 260K...
on Nov 05, 2018
Nec lt260 turns on but has a display problem
Some suggestions from NEC support:
Use the menu to select your source (RGB 1/2, Video, S-Video, Viewer or LAN).
• Ensure your cables are connected properly.
• Use menus to adjust the brightness and contrast.
• Remove the lens cap.
• Reset the settings or adjustments to factory preset levels using the Factory Default in the Adjustment Menu.
Hope this helps.
NEC LT260K DLP...
on Oct 23, 2018
Not finding what you are looking for?