NAD Audio Players & Recorders - Page 7 - Recent Questions, Troubleshooting & Support
Can i hook up a power amp to my Nad 7155 receiver and how
If the Nad has pre-amp out sockets that are currently connected to the power amp in the receiver. Then you can sever those link and put the pre-amp out into your Aragon inputs.
Otherwise I don't see how you can connect the amp.
9/7/2016 11:06:52 PM •
NAD Audio...
•
Answered
on Sep 07, 2016
How do I connect my NAD cd-player?
If you have a receiver with a digital rca input, buy a good quality coaxial cable and connect it from the digital output of you cd or dvd player. The digital/analogue converters inside the receiver are almost always better than the ones in the cd player. If running cd to a stereo receiver, just use a good quality pair of rca interconnect cables. Red is right, White is left.
6/16/2016 6:57:58 PM •
NAD Audio...
•
Answered
on Jun 16, 2016
NAD C320 Amp Problem
It could be a pre amp or amplifier problem and would require either replacement or a service technician to look at it.
5/9/2016 8:27:11 PM •
NAD C320...
•
Answered
on May 09, 2016
I get static and distortion in Stereo mode.
if you are reffering to a radio fm receiver, the issue is the signal strength is too low.so the multiplex transmission cannot be correctly unscrambled.mono reduces the cross channel interference.
use a high gain 12 db or above external vhf antenna to solve this problem
Where can I get my NAD amp repaired in Johannesburg?
Engineers in Jburg? Sorry I've got no idea. I'm an engineer in SW London and repair amps etc from all over the country, if you can pack it very well and post it here I'll fix it for you. I'll give you a price gude first, what's the model and fault?
Dave.
2/23/2016 8:57:07 AM •
NAD Audio...
•
Answered
on Feb 23, 2016
Receiver powers on then shuts down
If it's not happening when your speakers are disconnected, your problem is not in the receiver, it's either a wire touching at the terminals on the rear of the receiver, or a bad voice coil or crossover in your speaker. If you re connect the speakers and it immediately cuts out, disconnect all speakers and reconnect one by one testing the receiver each time until your receiver shuts off or remains on with all wires connected and you've fixed the problem. If it cuts out, disconnect the problem speaker at the speaker and test again. If it stays on, problem is in the speaker, if it still cuts out, problem is in the wire. Hope this helps. If you need further help, post a comment and I can help you troubleshoot some more.
12/4/2015 1:42:26 AM •
NAD C730...
•
Answered
on Dec 04, 2015
My old NAD C350 AMP diode turns green when the amp is switched on, says one click, but the second click sound does not appear, like in the good old days. What to do?
take it to the repair shop,,
unless you're an electronics tech,,, if so, reply & i'll take you further
10/6/2015 5:08:46 PM •
NAD Audio...
•
Answered
on Oct 06, 2015
Not finding what you are looking for?