Moen Plumbing - Recent Questions, Troubleshooting & Support


First clean out your cabinets under the sink. Second turn turn the cold water valve off, hot water valve as well.
You should be able to locate the sprayer hose as it will have a weight on it, this helps to pull the sprayer back when you are finished with it. Remove the weight by lifting up on the tab should be on the center of the weight.
Then you should see the hose connection.There you should see a button.Push it in and give it a little tug. The hose should be disconnected. Just follow in reverse order to reinstall.
I hope this is information is helpful. Have a blessed day.

Moen Plumbing | Answered on Nov 06, 2019


It should lift off gently twist as you lift maybe tap spout lightly back and forth with a rubber mallet

Moen Kingsley... | Answered on Sep 16, 2019


Turn supply valves off, turn on tub valves to release pressure, then remove the handle on faulty valve. Check to see if it has a plastic cartridge. If so, it sounds like the rib was broken on the valve and it is out of alignment with ports in valve body. Take the cartridge out and take to your favorite home supply for a replacement. The cartridges have a key rib that fits into a slot so turning the handle turns the stem and not the whole cartridge. You might also find a black washer and spring under cartridge, it's a good idea to replace washer whenever cartridge is replaced also found at home supply

Moen Plumbing | Answered on Sep 01, 2019


The hose or the counter weight is probably hooked on something under the sink.

Moen Plumbing | Answered on Aug 21, 2019


I know this probably sounds silly, but are you sure you installed the batteries correctly? Try another set of batteries.

Moen Plumbing | Answered on Aug 06, 2019


Take a set and go from larger to smaller until one fits.

Moen Plumbing | Answered on Aug 06, 2019


If by double you mean separated levers, there will be a nut and gasket/washer that needs to be tightened from under sink. Can be tricky as getting to underside of that area of sink is usually a tight area, and the nuts are good size. Most hardware stores will have a faucet nut wrench which has a swivel head for on and off and is designed to reach that area vertically. You might be lucky and have plastic nuts with wings that will allow you to tighten by hand. Word of advise, that area and related hardware can play havoc on the knuckles.

Moen Plumbing | Answered on Jul 14, 2019


There are screws that come up through the bottom. You may have to remove the faucet to tighten it. While you have it out, throw it away and buy a new one.

Moen 7840... | Answered on Jul 13, 2019


https://www.youtube.com/watch?v=KrqJnXksvnQ

Moen Plumbing | Answered on Jul 06, 2019

Not finding what you are looking for?
Moen Logo

1,353 questions posted

Ask a Question

Usually answered in minutes!

Top Moen Plumbing Experts

john h

Level 3 Expert

23424 Answers

Bruce Robin

Level 2 Expert

300 Answers

Mike

Level 3 Expert

4369 Answers

Are you a Moen Plumbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...